Crusher Mini Bike Build | $20 Mini Bike Gets a Tillotson 225!

This Baja Warrior mini bike Ike bought for $20 looks like a rat rod, and the factory 196cc engine is too worn out to run any more (we suspect it has frozen piston rings). Other than the engine and it's looks, this mini bike rides really well! The forks aren't bent, the brake works, and it rides comfortably, so we're swapping a 17hp Tillotson 225cc high performance engine onto it, making a sleeper mini bike!
Thanks for Watching!
----------------Go Power Sports Parts Used in Today’s Video---------------
Tell them CarsandCameras sent you at checkout:
Tillotson 225cc racing engine: bit.ly/34fqvtJ
Facebook: goo.gl/VR6mh2
Instagram: bit.ly/3T8njaF
Go Power Sports: bit.ly/3QKyODE
NEW MERCH: www.cars-cameras.com/
Equipment we use: www.amazon.com/shop/carsandca...
The following video features activities performed in controlled environments by knowledgeable persons. DO NOT attempt to duplicate, re-create, or perform the same or similar activities at home, as personal injury or property damage may result. CARS AND CAMERAS, the persons shown in this video and ANY CONTRIBUTOR, ARE NOT LIABLE FOR ANY such injury or damage. ALL CARSANDCAMERAS CONTENT IS FOR ENTERTAINMENT PURPOSES ONLY.

Cars and Cameras makes no representation about the sufficiency of any safety precautions and equipment used in this video.

[@digitalbarrito3555]

Ah man, the throwback clip, I cannot believe that was 5 years ago.

[@CarsandCameras]

This bike rides WAY better, and holy cow is it fast!! We're rebuilding the 196cc soon for a budget mini bike!

[@josefmechanic]

I bet with that external fuel tank y’all could fit a v-twin in there

[@Ralf57]

Dang it who else wanted to see them restore the Baja engine

[@FloridaMan0561]

These couple of videos are some of the best content that I have seen from either one of your channels. Not only did y'all save an older minibike,you also got that old,clapped out gonersville of an engine running again. I didn't think it had an ice cubes chance in hell of coming back from the dead.

[@megoingfast]

1:00

[@jasonhopper5072]

Hey Ike, just scored. 1983 Chevy Silverado, short box, 4wd, with a 350 in it, running, and driving, no rust for ......... $800 bucks in South Mississippi ! Now that’s a deal! Awesome mini bike though. I gotta get one of those!

[@Jack-bv7om]

14:41

[@jasonpetrich4141]

John got the runn away ride in the yard!!!!!! Ike got the runn away ride in the parking lot across from his shop, just recently!!!!! So you both got a good ride!!!!!! So lucky guys. Your doing great 👍

[@Stonedtothebone91]

the run away go kart had me in tears. totally wish you had a go pro on your face. my run away episode ended me up in hospital with 4 broken ribs a punctured lung and a fractured eye socket from hitting and going through the fence and into the neighbors house at around 40-50km. i tried to laugh and walk it off until i felt my eye start closing up and not being able to breath. bloody fun times i tell ya

[@blinderb1032]

I just had a 20 yo go kart project go full throttle on me. Lucky for me I was standing behind it and was able to lift the back wheels while my daughter ran over to hit the kill switch! Lesson learned!!

[@kbakeritsallaboutnobody.5761]

Get the tires to hold air and leave it alone. It's a keeper especially for when you have go kart and mini bike get togethers and have something reliable to use and not have to constantly work on it all the time.

[@thenormalplatypus3514]

Years ago my grandpa bough and old 25hp sailboat engine that had been sitting. He set in on a table and connected it to a battery to see if it would crank (remember, this engine was sitting for like 10-20 years) and it cranked, AND STARTED! It wasn't even hooked up to fuel. It started on 20yr old fumes sitting one wood table in my grandpa's shed and started bouncing everywhere.

[@Cee64E]

Do a RUST-oration. Clean it up but leave the rust on it. No touching the paint. Hit it with a flat, or satin clear coat to protect the look. Patch the holes in the seat with some "duct tape" looking material. Plumbing pipe for the exhaust.

[@scottcol23]

Dang I forgot about bearded pony tail Ike. I remember that 670 build. Time flies. Been subscribed since December 25th 2015. I remember because I was looking for preditor governor removal videos and found yall.

[@Jayb-xo5bp]

From Houston... Doodle Bug $150 + $14 carb, upgrading soon w/Predator 212 that I have. 2 karts w/Predator 212's. 1 was $225 other $175. Both ran, and still do perfectly. All 3 from OfferUp. Great area for great deals! Started as gandson/grandpa project(s). He has learned SOOO much! It's the time together that means the most though.

[@GearHeadWW23]

Just wanted to say thank you for fueling my addiction on a regular basis. Love watching you guys.

[@squidli4746]

Thanx guys this video. Is definitely back to home grown fun on a shoestring.

[@bashr52]

A project bike with a functioning kill switch! :)

[@NorthShoreScout]

im sure in other states just like minnesota. if you have a bike with more than 50cc/2hp it needs to be registered as a motorcycle/mooped. i got pulled over on my baja 200 i got for 70 bucks. so with this law its a pain in the butt to own a mini bike in minnesota. also our atv/snowmobile trails also dont allow motorcycles on them because they are special grant paid for trails. so thats why you might not find them in some states. awesome work guys!!