Cummins Fuel Injection Pump Replacement

This video goes over how to install the Fuel Injection Pump in a Cummins engine.
Part number used: Works for IP33 and IP21
Level of Difficulty: Expert
Approximate Time: 4 Hours
Vehicle used: 2003 - 2018 Dodge RAM CUMMINS 5.9L and RAM CUMMINS 6.7L
To learn more, visit: www.StandardBrand.com

[@chuckyschainsawdiesel]

Did u put it back at 9 clock after tighten the shaft with the 27 mm 🤔 ik u spun it just curious if ya timed it again so much detail but straight skipped the end

[@jeff-hl6fd]

Can i check the presure to make sure its broke

[@bigdaddyrichie88]

is the 5 in the 9 o'clock position for the 5 9 and the 6.7?

[@briangarcia5080]

just curious ,what would happen if it wasn't in the 9 o'clock, what would happen

[@domonickcolletti3528]

Cp3 knock.

[@TechnologicalSuper]

Ok so... the number 5 was on the 9 position because thats how you pull it out and the new one have to be in the same position right? So if mine was the number 5 on the 3 position the new one have to be in the 3 too.. and do i have to fill up the pomp before to try to stsrt the engine? thats my only 2 questions but everithing else is perfect, great video

[@jasontedesco3154]

No, doesn't matter how yours came out. They get reinstalled at the 9 o'clock position.

[@orianer]

It’s better to set the engine on TDC before disassemble, only then use the number 5 rule. Another thing - make sure the timing gear doesn’t rotate - it happened to me 😤

[@therampulasamel]

I would make zero sense to always set the pump up if you are not setting the engine up a certain way too. This step is missing information. Is that the correct position for engine on top dead center?

[@mariahdominguez4847]

When you tighten the nut on the shaft does the shaft move at all?

[@jeff-hl6fd]

Can i test presure

[@pedalharder8520]

Shouldn’t you have put the engine at TDC? Otherwise why bother putting the “5” at 9 O-clock position?

[@julianfish2173]

How the hell someone gonna use that tool if the radiator is on.

[@tylerwhite431]

I did lol I only took the top radiator hose lose

[@dirtdabbler611]

14:55 the fan is in the way. I can’t get to the head of the bolt to tighten it through the fan. Any suggestions?

[@user-oz4yo5bf3u]

So and that case ... You don't put the pump and just buy a new one!

[@leylanddaf992]

Wats the psi of the cp3

[@mabrams8740]

There are other tools that do the same job but are small enough to fit.

[@trevork213]

Throttle body housing🤣 on a diesel? ... ooook🤦‍♂️

[@jasontedesco3154]

Yeah, there is a throttle valve on the intake horn. Part of the government bs emissions crappie that gets put on these now.

[@trevork213]

@@jasontedesco3154 lol calling it a throttle valve is just silly...I know cummins does too lol but it's part of the egr system...nothing to do with throttle.