CYC X1 Pro and Stealth Chainring Options and Installation Guide

Рет қаралды 4,846

Golden Motor

Күн бұрын

Пікірлер: 22

@Robbrown92 11 ай бұрын

be nice to know what difference the different gearings make

@m1000black 5 ай бұрын

Excellent video of Chain ring replacement

@franklevelup5370 27 күн бұрын

That is a great video

@BramBiesiekierski 8 ай бұрын

Can you please explain the characteristics of each chainring sizing? Obviously its a gearing ratio change. But can you please explain which would be better for acceleration, and which would be better for top speed. And if there are any other things to consider which would influence a decision for one size vs another

@m1000black 5 ай бұрын

Smallest chain ring produces more torque, or asbi call it hill climbing power. Less top end. Each larger chain rings produce higher top end but you will lose torque on the low end. Depending on if your using a 72v set up it may not be an issue one way or another

@sladdster Ай бұрын

@@m1000black if i run a 52T chainring which 219 sprocket is best to run 53T, 63T or 72T? and what is the impact of each on torque and speed?

@Rs-im9gv 11 ай бұрын

It would be nice to know what the diameters are of the different size sprocket sets are when ordering. Also would be nice to know how far the smaller sprocket is compared to the original. That way when ordering the kits , there's at least a better understanding if one set will be too small or too large when ordering. I ordered my first cyc x1 pro gen 4 . And eventhough I would like the larger sprocket set , I jad to go with the smaller one because thie diameters are unknown. Some frames are not straight and have an angle that wouldn't allow a larger sprocket or maybe need spacers.

@franklevelup5370 27 күн бұрын

I had the 40 chainring and it reduces so much would not recommend it to buy

@markkus1134 Жыл бұрын

I have a press fit 30 on my bike and have the HD bafang which Lekkie kit do I use for the press fit the bike is a Niner 9 air new

@SteveLyons57 11 ай бұрын

So, I have the 38T (11/63) setup with a X1 G4. To confirm, I shouldn't need a new 215 chain if I'm only reducing the 38T to a 36T, correct?

@goldenmotorNA 11 ай бұрын

Yes correct.

@chrisregister8021 5 ай бұрын

Why are there 2 different versions?

@ridingmtl Жыл бұрын

Well done!

@NickyNicest Ай бұрын

Do you have any tips for unscrewing the bolts off the sprocket? I am having a hard time getting them to budge they are on there tight. Even if I take a flathead to the back to keep it from just spinning in place, it’s still so tight I can’t get leverage and don’t want strip or break anything.

@NickyNicest Ай бұрын

For anyone wondering the same. I tried heating it, i tried brakeleen and it wouldn’t budge. I ended up taking a dremel to the chain ring nuts to finally get it out mad then just bought some new bolts. Why they would use red loctite on an interchangeable/wear and tear part that can be swapped is absolutely beyond me.