CZ pistols sight setup. Eemann Tech front sight and rear sight.

[@jetA1pilot]

Best video I've seen on the CZ sight work - thank you, learnt a lot. I was worried about how hard I was having to hit the rear sight (and I gave up before watching this).

[@gl0bal7474]

its always impressive when we can watch a technician in action

[@oldeagle5500]

Excellent professional job. Thank you sir for such great lesson. Best regards and respects.

[@MrBlompod]

I didn't know there were different heights for the front sight so ended up with the 5.5mm which is too short for the eeman tech rear sight on my CZ SP01 so 67 dollars down the drain, just be mindful of that. It takes a 7 - 8.5mm front sight

[@darkpassenger65]

Thank you for pointing out the Allen key size. Do all CZ rear sights install from right to left?

[@paulhagiantoniou530]

Hello buddy. I install from either side

[@rgraz4929]

The trick is to try both sides to see which side goes in further by hand. This way, you'll find the easier side before you file/sand off too much material (if required). Factory sights with the CZ 75 family are installed from left to right which leads you to think you install the same way. But still CONSTANTLY try both sides as you work to sand/file the sight. You don't want to file/sand only to try one side when the other side unknowingly goes on with little resistance. Take it from experience.

[@lizzardking21]

Rear sight Doesn't work for some cz sp01.. I guess rear sight place maybe smaller or curved.. Also I could only istall from left to right not from right to left.. Why ?? Plz help

[@PCPointerDE]

I have to try it with a rear sight tool. Hammer does not work

[@juliustavares4662]

Hi can this sights fits the cz 75 compact? Thanks

[@joelbauer7583]

Who in the USA sells your products ?

[@Advanceauto999]

How much cost where to buy