my man treating the air impact like a semi auto riffle
@ivangutierrez73412 ай бұрын
Tengo uno así donde conseguiste kit de elevación mandalo por favor
@Wk32eze3 ай бұрын
Need some jba uppers
@pierre-etienneboiteau46593 жыл бұрын
Looks real great man
@MattyPow5853 жыл бұрын
You need some JBA upper control arms to get that knuckle off of your springs. J & J Offroad or Jeeperf for front diff drop brackets to correct the cv angles. Great video though, very thorough.
@thetrailratedoilburner56633 жыл бұрын
Actually, if you look at JBA’s page it actually says not to use with spacer lifts. The spacer changes the geometry and pushes out the coil perch to make this happen. That’s why most people recommend not using them
@MattyPow5853 жыл бұрын
You shouldnt need any of it with just a spacer lift, and you're correct that the website says that. Im just saying if you run into some contact issues when you downtravel, they'll work. A lot of people still use them even with the spacer lift. I started at 2", then 4", and now 6"+ and I've been running jba uca's the whole time. But if you dont absolutely need them, save your money lol they're expensive
@MattyPow5853 жыл бұрын
You shouldnt need any of it with just a spacer lift, and you're correct that the website says that. Im just saying if you run into some contact issues when you downtravel, they'll work. A lot of people still use them even with the spacer lift. I started at 2", then 4", and now 6"+ and I've been running jba uca's the whole time. But if you dont absolutely need them, save your money lol they're expensive
@jasontaylor98713 жыл бұрын
Your strut and UCA is touching because you need longer UCA's I had same issue with my Old Man Emu lift until I bought JBA longer upper control arms. The longer control arms will correct your driveline angles 07 Jeep Grand Cherokee Overland 3.0 CRD here
@Andreyhappy742 жыл бұрын
RESPECT ✊ ☺️
@carelnortje3817 Жыл бұрын
Hi there, I own the very same jeep and she seems dead compared to this one, is it possible for you to send me a list of thing you did to it?
@dmitryovd50663 ай бұрын
any issues with front drive shaft?
@pierre-etienneboiteau46593 жыл бұрын
Can I ask why you replace the lower control arm?
@D-RAIL_oOIIIIIIIOo3 жыл бұрын
@MODIFYD 15:28 How many Lb/FT did you torque that to?
@alexlowman81543 жыл бұрын
do you have a parts list for the build?
@jasontaylor98713 жыл бұрын
There's a guy on JeepForum under the WK section that will sell you an OME lift far cheaper than anywhere online Buy the OME lift then get some JBA UCA's and your good to go.