Рет қаралды 11,734
Hello viewers....In this video I will make a high speed and torque BLDC MOTOR by using some scratch parts collected from hard disk, dvdrom.
This motor is a 12 teeth 14 pole bldc motor.
12 turns insulated copper wire in each teeth with 0.5mm wire and the combination is Star for high torque.
🤗If you want to support my channel🤗 By Me a ☕Chai☕ -- buymeacoffee.c...
Follow me on -
WhatsApp Channel Link - whatsapp.com/c...
Instructables -www.instructab...
Instagram - / _elecobot_
Facebook - / 100077394460408
Parts Thai I used
1-armature collected from laptop dvd rom BLDC motor.
2-out runner collected from cpu cooling fan magnet holder.
3-5x5x2 LXWXH nodiyum magnets collected from dvd rom laser pointer.
4- 0.5mm insulated copper wire collected from old transformer.
5- motor shaft from dvd rom slider.
6- Glue (Flex quick).
7- pvc sheet.
8- 30amp ESC.
9- soft(wood) match sticks.
10- heat tube , header pins.
11- battery 12volt.
12- Soldering iron.
Step to make this high speed and torque bldc motor watch this full video.
Armature winding pattern is AacCBbaACcbB
Capital letter - clock wise winding
small latter - anti clockwise winding
at last connect three ends of the three wires together and use other three start points with esc.
Thanks for watching.... don't forget to Like, share and subscribe my channel.
diy arduino 10 channel transmitter and receiver video link -- • Arduino 10channel tran...
How to make bldc motor video link -- • PVC BLDC motor DIY
how to make Arduino helicopter video link -- • How to build a rc heli...
how to make flying ornithopter video link -- • Diy flying Ornithopter
how to use Hard disk as ESC video link -- • How to run any BLDC mo...
Arduino Bluetooth control monster truck video link -- • Video
Arduino Bluetooth control high speed car video link -- • Video
Diy 12 volt drill machine video link -- • 555 motor drill machine
Diy CAN car video link -- • how to make dc motor c...