DIY LEAD JIG MOLD

[@joeyg7446]

Great Video! By showing where you failed in your 1st attempt and corrected it proves you are a true craftsman. You have made an excellent lure mold. Thank You...

[@mattnaylor145]

I used these with the Team Catfish weight slides to make a kzbin.infoUgkxdmsDj7fQXe77DC0l7P7ua8B3PiESUubM Carolina rig and they were perfect for the ponds I fish. I have also used them to make 3 way rigs and these work perfectly. Haven't had any issues with them snagging in rocks or in weeds yet.

[@jamesfosterfishing7040]

Inspiring brother! Thank you!

[@asfcharters1]

You should bake that mold on the oven at lowest temperature for a few hours to make sure there is no moisture left in the plaster or other could be very dangerous!

[@tayfunoztayfun9691]

Isn't the lead casting soft. Do you add anything else to it.

[@entengfishingadventurestv4286]

nice master thanks for sharing

[@gabrielaguiaroutdoorwoodwo786]

What is the stuff you are using to make the mold out of ?❓❓👍

[@zelenang3537]

gypsum powder

[@miamiwax5504]

Do they sell commercial molds for vertical jigs?

[@ajspearfishingdiaries1825]

Can i ask how to make a smooth one on the mold?mine always keep on boiling when i pour the lead..

[@TRYINGTOFISH]

make sure the mold is super dry. Try to pour 3 to 5 times to make the remaining water to evaporate.

[@jamesfosterfishing7040]

Thanks I had this same thing happen

[@hards7yl3]

What are you using to separate the second gyps detail?

[@TRYINGTOFISH]

petroleum jelly or oil

[@tayfunoztayfun9691]

How hard is the jig with only lead?

[@TRYINGTOFISH]

The hardness of the jig is enough for it's purpose.

[@VizagVlogs]

Tried very hard. Successful

[@jhayoutdoorandfishingadven1940]

Sir ask ko lng bkit butas butas cya pag natapos ng matuyo ung tingga

[@slimpslimp2365]

dry the molds normally and everything will work out

[@cakkol3767]

Cak kol josss

[@jhayoutdoorandfishingadven1940]

Gnyn din kc ang akin pag naibuhos ko na s molde ko pag natuyo cya butas butas ung yare ng pagkakamolde. Anu kayang pwedeng gawin slmt bro

[@TRYINGTOFISH]

Dapat tuyong tuyo yung molde. Try mo ibilad sa araw ng ilang araw. Pag natuyo sya magiging maayos na at makinis yung jig

[@habagatrandomvlogs7444]

ano po mga materials at saan makaka bili?

[@TRYINGTOFISH]

gypsum powder , tingga at stainless steel na wire meron yan sa hardware. Yung tingga gamit ko lumang sinker.

[@saadaaly7968]

the mistake u made that u didn't keep the plaster in sun ...u should keep it in the sun for 2 days 2 remove the moisture And heat the mold before u cast

[@TRYINGTOFISH]

Yes Lesson learned the hard way.

[@aa-vu4cm]

NA....! ILYET LEHET KALAPÁLNI IS NEM KELL A HOKOSZ POKUSZ. tök feleslege volt az egész........

[@cfonvip5151]

Oh, don't you worry. Judging by your little hands, you'll have a long time ahead to improve. And maybe on the way, you will also learn how to speak. Trust me!!!!!