DIY Replacement of a 2011 Toyota Tundra Unit Bearing - Saving $500

In this video I am down in my buddy Caleb Harris' (YouCanMakeThis Too) Shop. He called me and asked for assistance on replacing the unit bearing. Was not a hard process but does require an above average of mechanic skills.
Music: AmpleTunes
All links provided are Amazon Affiliate program and we earn slight commission on purchases on links provided.
Tools I used are at the end of the video.
Special tools that are a must:
39MM 12 pt socket
amzn.to/39pc8Fw
Other Tools: Capri Tools
Offset Box Wrench
amzn.to/2QP3f1r
Ratchet Wrenches
amzn.to/3dwKuYr
1/2 ratchet
amzn.to/39pKo3q
Wobble Extension
amzn.to/3fqIcMS
Channellock Pick Set
amzn.to/3dm4NaV
GearWrench 3/8 Drive Ratchet
amzn.to/3czEr5U
1/4, 3/8, 1/2 Socket Set
amzn.to/39sQNuO
Tekton Mechanic Pry Bars
amzn.to/3dm4NaV
Disclaimer:
Due to factors beyond the control of JKCanvas, it cannot guarantee against unauthorized modifications of this information, or improper use of this information. JKCanvas assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. JKCanvas recommends safe practices when working with power tools, automotive lifts, lifting tools, jack stands, electrical equipment, blunt instruments, chemicals, lubricants, or any other tools or equipment seen or implied in this video. Due to factors beyond the control of JKCanvas, no information contained in this video shall create any express or implied warranty or guarantee of any particular result. Any injury, damage or loss that may result from improper use of these tools, equipment, or the information contained.

[@AntonioClaudioMichael]

Unit bearings have gotten a ton easier to deal with and a ton faster to swap

[@JkCanvas]

This was a lot easier than I thought.

[@AntonioClaudioMichael]

@@JkCanvas yeah there pretty easy with the right tools

[@RenegadesGarage]

Jk Canvas.. Very well explained. Aside from actually torquing the axle nut, nice job. Thanks for sharing it.

[@JkCanvas]

Thank you for the kind comments.

[@AntonioClaudioMichael]

Good to see ya Will

[@JkCanvas]

Thanks buddy

[@ifitsnotbrokenfixit1193]

Easy how to.

[@JkCanvas]

Thanks for stopping by. I thought it was fairly straight forward.

[@shaun7126]

Next time put a lug nut on the studs so your pry bar don't mess up the threads on the studs