DIY YAMAHA 100 HR. SERVICE PART 2

[@WillStuart-rg2ee]

Excellent detail! Good job.

[@hunterfarr2124]

Do you have part numbers for the part that goes over the 3 washers and the piece that goes over that? You had to pry on it to get it off. Thanks.

[@oceandeepfishing4555]

Hunter let me look. I'll add them to the description if I do,but I won't have time until tomorrow. Thanks for watching.

[@oceandeepfishing4555]

Yamaha Genuine OEM Spacer & Collar Set Spacer OEM Part # 61A-45538-00-00 Collar OEM Part # 61A-45527-00-00

[@oceandeepfishing4555]

I don't have the three washer part number. I used the ones that were on the shaft already. I'm sure you can order them from your local yamaha dealer.

[@paulsweeney3731]

Great Video & VERY INFORMATIVE. 🎣👏😉👏🎣

[@asianseaanimals]

Nice home repairing

[@johnolenczak1552]

You missed the alignment of the anode before removal

[@oceandeepfishing4555]

I did look at it before removal. But I didn't make a comment on it. Because the new one doesn't matter without the fin. It only fits in one way. There's no fin to detect tracking.

[@GmailAccount-g5x]

Nice video.

[@jaybee006]

Thanks for posting this. I have my 100-hour service due on my F200. Is there a specific Yamaha grease required or just any marine grease for the shaft?

[@oceandeepfishing4555]

@@jaybee006 lucas marine grease is the best to use in my opinion if you can get it. Last time i greased the fittings i couldn't find it so i had to use another. Thanks for watching. If you need any help let me know.

[@oceandeepfishing4555]

@@jaybee006 also for your information this 100hr service i have two videos. So to look at all of it see part 2 also to finish the complete service.

[@jaybee006]

@@oceandeepfishing4555 Yessir, I have watched all three (oil change from 20 hour service, Part 1 and Part 2 from the 100-hour service). Very helpful!

[@andrewanderson2388]

You should go back and show everyone how you finally got the leg off. you missed the bolt under the anode I believe.

[@oceandeepfishing4555]

Hi Andrew. A million thanks for watching the video and spending your time on my channel. So I did finally get the lower unit off if I'm right on what you are referring to. I did find and remove the bolt under the anode, which I'll go back and review but I thought I did show that bolt. but it was a bear getting the lower unit loose and the camera shut off just at the time it cut loose, but I didn't realize it had. So on my next time I replace the water impeller, I definitely will show that. Appreciate your comments. I hope that answered your request. If I can do anything else, please let me know. Tight lines....

[@oceandeepfishing4555]

Andrew, I just looked back on that video and I definitely showed that bolt and removed it in the very beginning of the video. Check back on it whenever you get a minute . Again, thanks for pointing that out. I do appreciate anyone catching something that I might of missed. It only helps me do better