Double barrel wood burning stove

Wood burning stove

[@MrSprintcat]

Believe it or not you'd be better off sucking the air from the floor. By grabbing the cold air from the floor you warm up all the air in the building. If that makes any sense. Good job thanks for the video

[@davekauffman8727]

I like your radio station, my kind of sounds. The stove is nice too.

[@Uticagreens]

This is the best one I have ever seen. Thank you.

[@husseyrj]

Well done! I built the same barrel but without the upper barrel ducts. I put a floor fan behind mine to get a draft across it. I have a 25 x 35 ft non-insulated detached garage and I have no issue warming it. A $80 pickup truck load of hardwood goes a long ways. For paint I used Rustoleum Ultra BBQ paint. It's been on there three winters now without burning off. At the end of winter I do clean it up, touch up the paint, and move it aside.

[@RustyCarnahan]

Just gave me a couple great ideas for my wood burner. Thanks.

[@RANDALLOLOGY]

So this was done in 2016, you should do a update with it in action and show digital temps and how it has done for the past 2 years. I have a double barrel heater and I like the duct fan concept.

[@lucionkoinva5635]

So tell me what kind of pipe you have in the barrel going to your blower? Thats a cool looking stove .

[@doneown503]

he does not answer, after 5 years,

[@travfinger8654]

Just a suggestion. I lined my lower barrel with fire brick so it wouldn’t burn out.

[@jaydeaton9085]

What are you using for inside pipe? I really like the simplicity, I want an outside burner in a shelter to pump heat into my garage.

[@urgentcareguy3]

Just wondering if you have any footage of your upper barrel internals.

[@02lswith22s]

That’s what I wanna see

[@oldsteamguy]

i like the fans a lot. do you have a way to clean out the upper barrel?

[@junkcarz4720]

Have you cooked in it

[@junkcarz4720]

How much was kit

[@Blackford86]

I'm guessing the bottom stove pipe runs through the top barrel and your fan blows around the stove pipe in the top barrel, correct

[@sonofrobert]

I'm thinking those two fan intakes join into the one air outlet. Why not just blow a big fan over the whole thing, less complicated.

[@scottmcintosh2988]

Place sand under the grill in the bottom barrel as it prevents bottom burn out and makes the barrel last longer !!!

[@brosselot1]

How did you seal the air tube into the barrel

[@charliebrown4007]

barrel stove you could do like i do i make a big fire with kndling and i let it burn for 20 minutes than i pack full the stove with large logs and i turn the air on high in till its burning good than i dial the air down and it burns for 24 hrs

[@wwsummers]

Wondered about upper barrel internal construction too

[@aroldfut]

Add me to the list wondering how the two rear ducts and side ducts connect without picking up smoke. T-connection and 90 degree elbows? Only Jimmy Alder knows!

[@danjam67]

Roll Tide!

[@hercules3782]

All this make no sense at all,

[@02lswith22s]

You’re not very smart then if u don’t know what’s going on