Drysuit valves, tightening them up without causing damage.

[@jean-marcb8746]

Thank you very much for the video : both complete and clear. Too bad the link to Apeks valves service manual is dead.

[@jakobschubert4106]

Is the inflation valve glued in?

[@AquaTech225]

I just tape the back of the dump from the inside and with a small glass with a spout pored a rubber glue from the outside into one of the holes on it and let it sit flat long enough so when I picked it up to wear it it wouldn’t leak out.

[@SuperScubaTim]

When changing a shoulder dump, should you use a sealant between the port and the outside valve? If so what type?

[@capitan8794]

Who came up with the idea of a exhaust valve for dry suits?

[@nomade_dreub2138]

Don't buy a suit here I don't answer any inquiries after the money deposit