Engine preparation for swap from Audi S4 B8.5 to B8. PCV Valve.

I finally got some time and now I'm preparing the engine from 2013 Audi S4 to be installed into my 2011 Audi S4. Very similar engine, but not 100% same.
As an Amazon Associate I earn from qualifying purchases. #commissionsearned.
Also, I personally use or have used the products featured in my links and only recommended them if I feel they are of good quality.
Headlight restoration kit:
CERAKOTE Ceramic Headlight Restoration Kit - amzn.to/3NKwomx
Power tools:
1/4" Milwaukee M12 Fuel ratchet - amzn.to/3sBmcUm
3/8" Milwaukee M12 Fuel ratchet - amzn.to/3rJLMY0
1/2" Milwaukee right angle impact - amzn.to/3oGqQQ6
1/4" Milwaukee M18 FUEL Hex Impact Driver amzn.to/3Jk1r6r
Tools:
Triple Square Spline Bit - amzn.to/3Lq398i
Mityvac MVA6851 Fluid Extractor - amzn.to/3sCU2IV
Arcan Underhoist Support Stand, 3/4 Ton Capacity - amzn.to/3Jc2Uf8

[@whistlingdiesel]

Funny that one have to rent an injector puller from Autozone, it seems to be a simple cheap part, great work ...but I'm happy that this is not my job 😁😁

[@HETPEZB]

Don’t know why, but I got a set like that for myself too to skip a trip to Autozone :)

[@fastboatster]

Did you swap the entire wiring harness from the 2011 to the 2013 engine?

[@HETPEZB]

Harnesses are different. I kept ‘11 harness for ‘13 engine.

[@fastboatster]

@@HETPEZB got it, thanks again. I think you mentioned that in the next video, I just got too impatient)