EzCad2 Tip : How to Adjust Laser Timing

[@stevegarland7075]

As always informative even 4 years later. Thanks

[@yfaheem]

v useful video, I have been trying to write text and always turned up missing some areas, I will fine tune the delay now

[@cocosong940]

thanks so much for share this!!! Many clients recommend your video to me for how to use the fiber marking machine!!

[@paulriley5940]

It there a way to adjust the red laser light? Mine seems to be off 1mm compared to where the laser engraves.

[@olivierw7405]

Yes it's easy you have to go into "config" to set that

[@babblecharms]

I have the same laser I haven't figured out what the( all calculation tab) Is for. would appreciate any tips on this thank you Jeff

[@jefferyj]

Did you happen to see my video on hatching? I discuss the 'all calc' setting there (if that's what you're referring to). Video is here: kzbin.info/www/bejne/oZ7bdZiGl617hc0 It basically just calculates multiple objects as a single hatch so the laser will mark in the most efficient path to save time when marking. It can sometimes have strange results on the actual fill though...

[@ajfreeze215]

awesome and helpful video, thank you for posting it!

[@jaijoshi7419]

Very nicely explained 🙏🙏🙏🙏🙏

[@chrisphillips9089]

So I have a question, when doing hatch and filling this step I get it down perfect. Then when I try to create text or anything with hatch it leaves lines past my design. Any suggestions?

[@RavenRockMachine]

Hey Chris did you figure this out?

[@KRSbumpbars]

Thanks! Fantastic help

[@erinspalding5764]

I have a 30W Fiber Laser with rotary axis. Can you make any sense of EZCAD settings for rotary axis to do ring engraving. There seems to be redundant options for rotary marking text or rings. I've been doing many experiments with 29.79 diameter silver rings but not getting EZCAD settings to match rotary axis movements. Thoughts?

[@jefferyj]

I don't have the rotary, so all I can do to help is direct you to a few facebook groups where you might find assistance: facebook.com/groups/250911899106529/ facebook.com/groups/440091022989424/ facebook.com/groups/300139820848489/

[@3DCA]

Could you please share your screenshots of the ring engraving?

[@mysafename1694]

This is five years old. Do you have anything that's more current . The software has updated.

[@menanabil8295]

Could you please send me this user guide?

[@NAV3DP]

Very helpful. Thank you

[@jorgebrandaosilva2833]

ola gostei muito dos seus vidio.tem como vc traduzir em portugues brasil vou ficar muito contente agradeço