Is the primary clutch supposed to move in and out freely like that? I have a g16 mine is real tight. Was also really hard to get the old belt out from under it. Do you think i have other issues?
@WeekendHobbyMechanic2 ай бұрын
No issues with your clutch.
@ChrisLee-sm1rl Жыл бұрын
I pulled and tried to roll off the old belt and I cannot get it off. Any suggestions? Is there a drive belt removal tool?
@WeekendHobbyMechanic Жыл бұрын
I just cut them off. And then install the new one.
@travismccrary14306 ай бұрын
I have a Yamaha g1 I just put a bran new starter belt on it I went maby a mile down the road and it somehow got stuck in the secondary clutch belt what are some suggestions please and thank you it’s been a pain in my butt lol
@WeekendHobbyMechanic6 ай бұрын
Wow. There is something wrong with the bracket causing alignment issues or the belt is not tighten enough.
@travismccrary14306 ай бұрын
@@WeekendHobbyMechanic thank you 🙏🏼 I’ll check it out I just bought a new belt because like I said the last 1 lasted a mile lol I’ll double check make sure everything is aligned Is there a way to tighten the belt? I couldn’t find anything on it tried looking it up but nothing
@WeekendHobbyMechanic6 ай бұрын
@@travismccrary1430 I have a video on the starter belt but not for a G1.. kzbin.info/www/bejne/mWm9o4lsaKmJZq8&ab_channel=WeekendHobbyMechanic
@scottwhite9145 Жыл бұрын
So u didn't explain how to losen or tighten the belts
@seankelly81403 ай бұрын
Completely wasted my time waiting for the same thing
@byronmill3 ай бұрын
There is no adjustment to the belt to tighten it or loosen it. The shaft centers are fixed. The belt becomes tensioned as the centrifugal clutch begins to move when the engine is throttled up. If the belt does not tension when the engine is throttled up then you likely have a mechanical problem with either your front or rear clutch.
@lloydwarner68532 жыл бұрын
my 2017 Yamaha gas cart has been losing power in the sense that going uphill is difficult. now even just two people i goes super slow to slipping. the drive belt is very loose. how loose should it be? i only have 50 hours on it. is there anything else that could cause it to lose power going up hill? fuel filter?
@WeekendHobbyMechanic2 жыл бұрын
Measure the width of the belt (Should be 1inch wide or more). Check your air filter, clean it. You can jack up the rear, start it up and watch the clutches to make sure they're working.
@98integra872 жыл бұрын
My belt is 1 and 1/4 inch so I should be still gold right?
@98integra872 жыл бұрын
It's a 2000 Yamaha g16
@nickedwards592 Жыл бұрын
Did you find a solution?
@jeffbeckbenito1432 жыл бұрын
Nice!! May i know the size of the belt? Tnx! More power
@WeekendHobbyMechanic2 жыл бұрын
Yamaha part number: JW1-G6241-10. Length 42-3/8”. Width 1-1/8”