Fitting an Onduline Shed Roof

Recorded in May 2020
Having reinforced the shed base in my previous video, here I'm fitting Onduline sheets to replace the old felt. I'd a cunning plane to make the roof up in two removable sections, so that no-one would have to dismantle it sheet-by-sheet when it came to moving again.
Onduline's website has all the details on installing their products:
uk.onduline.com/en/diy/planni...
Facebook: / ollywrites
Instagram: / opjcarpentry
Twitter: / ollypj
Thank you for watching!
Olly Parry-Jones

[@MikeAG333]

All the best for 2023, Olly. Horrible stuff to cut, Onduline. I actually spray my saw with WD40 as I cut, which helps reduce the amount of tar which sticks, and helps lubricate the saw plate through the kerf. Clean afterwards with white spirit. Or, use your oldest most worn out saw, and cut it up for cabinet scrapers after you finish the job.

[@OllyParryJones]

Hi Mike, All the best to you too. I was using an old saw, which only seemed to make it harder. Plus I was trying to save time but cutting two poorly supported sheets at once... Must've taken me nearly ten minutes! Thanks also for watching and commenting.