FIX THAT DRAGGING DOOR FAST | Trimming Door After New Carpet Installation...DIY GUIDE

[@rehaanq]

Nice video mate. Just bought one those pump bags. Another tip is to use masking tape over the cut to prevent chipping.

[@stevesterl]

Why do you need to mark where the lowest point is if you take 12 mm off the full bottom off the door anyway?

[@jonnygunner65]

Because he’s a plasterer first and foremost….

[@gixxern]

I think just to ensure the opening are level at either side from floor to door, rather then cutting straight off the doors original length

[@michaelbrown-yr5nn]

It's still a straight cut from the lowest part and works out in-between 12mm

[@northeastcorals]

Most impressive part was seeing all those used flat head screws going straight in with an impact without the bit jumping out & smashing into the doorframe!😅

[@johnmartinez7440]

Was close at 6:08

[@woody1380]

I make it a mission every time I get chance to throw flat head screws in the bin. We've moved on, the world doesn't need those crappy things anymore 😂

[@laurab9790]

Great video. Need more of these for a novice like me 😊

[@DIYForBeginners]

Glad it was helpful!

[@drittz7840]

Cheers for this. Really helpful video.

[@thewolfydragon1989]

What id you dont have a circular saw and dont habe a garden or anything? Lol will a door plane work just slower? Only need to knock down 1cm

[@ThePlasterer]

Nice one mate 👍

[@DIYForBeginners]

Thanks pal!

[@MarcusT86]

Brilliant video buddy! Looking forward to more of your other vids outside of plastering

[@DIYForBeginners]

Thank you mate - really appreciate it!

[@jonathancowdin3775]

Good method for a cut, bad method for pulling a door, use the hinge pins dude

[@delphiproductionsmusic]

can you do a vid on FD30 doors

[@mydrouno]

I still use my 5-in-1 under a door to put it back 😂. Just a habit from when I was a painter.

[@ronswillson9847]

Any way to adjust the hinges instead of a full cut?

[@bravo2966]

Then you'd have a problem with needing some taking off the top of the door.

[@racindave88]

Why didn't you just pop the hinge pins out ?????

[@julianb64]

Most hinges in the UK don't have loose pins, it was probably habit

[@mamacindyrogofsky495]

He sounds like Shawn malone from Goggle box.

[@CarlBrown-m3w]

Are you a joiner now

[@jonnygunner65]

Impact driver with flat head screws = noooooooo 😳😳😳

[@matty2704]

Damn, you have nice eyes matey