FIXDRY Filament Dryer Box - Initial Review

[@doncarpenter6227]

Thanks for your review. I like your style of no-nonsense information. It was very helpful but it did seem lacking for anything other than low temperature materials. I have been looking for a dryer that will work well with nylon and other materials that need higher drying temperature. In my research I have found that some dryers claim to have a 70 degree temperature but as it turns out some of them are 70 degrees at the heating element (bad) and some actually are 70 degree air temperature (good). 1) Where is the temperature sensor in this dryer? 2) Does it actually get to 70 degree air temperature? 3) Does the fan run all the time, or vary in speed, or intermittently turn on and off?

[@3DPrintscape]

Hi. Thanks for the feedback. I can try to answer your questions but cant verify the actual temp. 1) It looks like the sensor is in the front center of the dryer, a little forward of where the filament sits. 2) It shows it gets to 70 but i dont have a way to actually verify the air temp. 3) the fan runs the entire time the heater is being ran but doesnt if its not. From my understanding, its used to help push the humidity out of the dryer.

[@doncarpenter6227]

Thanks, I appreciate your input. @@3DPrintscape