Fixing My Very Slow Filling Toilet Cistern

[@MichaelMoutou]

Really good video, straight to the point

[@uktony1525]

Thanks for this, I have the same problem on a similar toilet, 3 hours to fill at the moment!.

[@revcole7]

Great advice, thanks for sharing.

[@seyouintea]

Thank god you weren't the first vid i went to, all the other guys just changed the washer first before dismantling the whole jax

[@meganjb10]

Check the obvious the washer first before you start taking it apart from underneath ,should of known when I seen putting wood filler in before removing all the rot ,splicing new piece of timber is the answer

[@Complain2023]

All you need to do is change the faulty inlet diaphragm. You dont even need to take everything apart

[@80sTrashTrauma]

great video as i gone through a similar issue the little inlet valve is the answer £2 on ebay give or take. full system flush and inlet valve dont make £50 i'm going to buy a couple for spares for the future

[@lennykelly9952]

Very good video you covered everything it might be.

[@PatrickMaguire-n9x]

What's the stillsons for 😅

[@650GSF]

As a site maintenance guy in a school, I am always fixing toilets, I could strip one down and reassemble it blind folded lol

[@mickltlbjhbih3909]

Send me the address and I’ll post you on your medal

[@inaayathashim8806]

Thank you! Really helpful.

[@shouwill]

Looks like tha siamp washer was faulty ie spilt so repair insitu possible - £3 and 10mins, but you now know all else is okay with feed... An all round helpful video post. Cheers.

[@Fifury161]

Can't find the washer, so a new unit it is (available for under £10)

[@Marky745]

When the diaphragm perishes, parts of it can block the outlet since its such a small hole. Unblock it and renew the seal. You're welcome.

[@davidmcfarlane9936]

This gave more info than the video. The video just tells you how to replace the whole unit.

[@Fifury161]

I have the same valve with the perished diaphragm - sadly it appears impossible to find a replacement diaphragm. I can't find an identical unit, however a similar one is under £10. Of course it appears I don't have an isolator valve so will need to turn the mains off at the stop cock!

[@juleeng1189]

Thanks for this! $6 part and all fixed!

[@williamord9561]

What a cowboy all that when it only takes a £2 membrane wash

[@taxirob1297]

kzbin.info/www/bejne/aX3QkoV7hsengdksi=QEFOaLmUWpgE9Uy3

[@mervynjones1759]

What is the name of a top mounted push button cistern? Thanks anyone know?

[@derekelford4924]

Plumbers mate,on a rubber washer ,lol

[@Rocketed12]

My inlet diaphragm seal is new and still no water entering cistern - The tube pipe which unscrews is finger tightened. Silicone seal at top of tube is fine. 🤷

[@peppermintmoon7354]

Thanks!

[@thegreenfieldsite]

Perfect, thanks!

[@reidaz99]

This is why plumbers are loaded, go the massive long way around before checking the obvious

[@one4all126]

I don't think you're supposed to use PTFE on plastic fittings...

[@davidm3maniac201]

Your not. Lol