Floor Jack Complete Seals Replacement

[@SuperMag95]

Thank you for saving my old floor jack. Bought a seal kit vs a new 3.5 ton jack. The design was the same for an ac delco jack.

[@ktgarage1126]

You’re welcome! It’s good to know I saved you some money and time by fixing the old jack instead of buying new one. Appreciate your support on the channel.

[@frankiieps3651]

Thank you for the this videos I just bought a brand new Daytona jack 3ton that didn’t work properly changed just the outer seals now I’ll definitely change out the rest! Definitely subscribing to your channel

[@ktgarage1126]

Thanks. Great to know that the video is helpful!

[@JoseLuisSanchezSola-ph3gw]

So this kit works for the Daytona 3 ton Jack? Just bought one and took it down to México and now it's leaking and one of the pump seal is leaking but don't know if it will fit

[@JoelMcPherson-c9t]

Nice job, I'm going to repair my jack.

[@ktgarage1126]

Thanks. Let me know how it goes!

[@JoelMcPherson-c9t]

@@ktgarage1126 I did the rebuild and it doesn't leak any more. Thanks again for the video.

[@ktgarage1126]

That is great news. Thanks for the follow-up

[@vaf300]

Thank you for the tutorial, BTW That chassis behind, what are you building? if you don't mind me asking? is that a GM pushrod engine? aluminum head, cast iron block, manual tranny.. Nice!

[@ktgarage1126]

Hi. Thanks for the interest on the chassis. I do have a video to explain what it is. I will add a link at the end of the message so you can check it out. It is a chassis from Schwartz Performance. It is specifically build for the 1970-1974 Dodge Challenger. It has a supercharged Hellcat engine with a T56 Tremec tranny. 9” Ford rear end. Coil-over in 4 corners. 14” Baer brakes. It’s for my 73 challenger project that I will be building very soon.

[@ktgarage1126]

Here is the link: SEMA Hellcat Restomod Dodge Challenger Build Part 2 kzbin.info/www/bejne/q5KkaXhmaL2keqM

[@vaf300]

Thank you for the link. It's an amazing build!!

[@ktgarage1126]

@@vaf300thanks for following my channel!

[@Dusty2040]

Mine leaks when I lift up the car does that mean it needs seals replaced ?

[@ktgarage1126]

Yes, most of the time it is the seals! See if can find out where it leaks. Mine leaks slowly so I don’t know which one. I had to replace all the seals.

[@Dusty2040]

@@ktgarage1126 it’s right where those thick springs are where it presses on the bottom of the handle area no what I mean?

[@ktgarage1126]

@@Dusty2040seems like your high or low pressure cylinders seals are leaking. Worth replacing all the seals while your at it. Do same thing I did to mine…

[@Dusty2040]

@@ktgarage1126 ok I’ll give it a go and get the seals thanks man

[@Brian-ff7tw]

Great job on the video! But....$50 for 7 o rings is highway robbery! Getting so tired of this scalping siciety we live in

[@ktgarage1126]

@@Brian-ff7tw totally agreed. It’s a rip off. I almost didn’t want to do the rebuild because of the price of the seals!