icp pressure to low at stall. check the stc fitting on the high prussure oil pump and the dummy plugs in the valve covers
@haleyy687 жыл бұрын
Very obvious. High pressure oil issue. The ICP pressure is dropping every time right before it dies. Depending on year modelit could be Hi pressure pump-Dummy plugs and stand pipes and STC fitting.
@trent12341089 жыл бұрын
My truck would do this the 1st time i started it. only the first time. I replaced my ICP sensor with new from international including pigtail yesterday and this morning it started and ran normal at 18 degrees F outside. no plug in.
@dieselauthoritymillertime12763 жыл бұрын
Ficm looks good
@Manall410 жыл бұрын
Camshaft position sensor is bad possibly maybe crankshaft position sensor, have u checked the fuel system, blue smoke indicated overload and no burn off u could have a ficm software issue
@Odinaryman236 жыл бұрын
Got to be the IPR
@elgordoIII10 жыл бұрын
blownfuel2010 blownfuel2010did you ever fix your problem with your 6.0? If you did what was the problem, and how did you fix it? Thank you
@blownfuel201010 жыл бұрын
Yeah... there was a tiny piece of the green IPR o-ring UNDER the IPR screen, clogging the orifice. So, cleaned it again and put it back together, and no problems! However, got a new problem with the EBP sensor. Will post new vid...
@Manall410 жыл бұрын
Did u ever figure out the issue, mines a 2003 and it rough starts in morning and misses til it warms up then runs fine but now it misses all during the day
@elishakaminski98163 жыл бұрын
@@Manall4 did you figure yours? Mine 03 was just lime yours untill became line the one in the video
@concreterich2 жыл бұрын
Did you figure out the problem, mine was doing the same thing after I changed the IPR Sensor
@avickers999 жыл бұрын
icp look bad 8.5 voit needed to run
@juliochavez32828 жыл бұрын
did you ever figure out what was the problem
@luvtawac10 жыл бұрын
Hey did you have any luck figuring out what the problem was?
@emramz185 жыл бұрын
I have the same problem did you get it fix
@SSPanzer10009 жыл бұрын
Your ICP pressure looks low
@frijolsur10 жыл бұрын
Where can I buy one of those ,man I truck just dint want to start this morning gave me codes of low circuit what does that mean???
@Manall410 жыл бұрын
Low circuit codes mean the part is bad
@kylerollenhagen8663 жыл бұрын
Battery issue
@williamdawson211110 жыл бұрын
i have a 2004 for E350 super duty turbo diesel that starts good and runs for a while then starts missing and shuts down
@Manall410 жыл бұрын
That's a electrical issue, check your ficm wiring, had one of my vehicles to do that and that's what it was
@tensecondbuickgn10 жыл бұрын
your MAP readings stay the same when started from what I saw
@Manall410 жыл бұрын
Yea I had this issue too try changing ur map air flow sensor but also change air intake temp sensor as well
@certifiedlawnpros11 жыл бұрын
Any news? I just did an egr delete and oil cooler replacement. It took forever to start, then finally cranked over, ran like garbage and killed itself. Now I've been trying for hours and can't get it to kick over...