FROM ZERO TO HERO, P42 PISTON WORK!!

[@rncboy2]

A helpful tip, a guy can cut little strips of sand paper whatever grit a guy prefers and super glue one end of the strip to a wore out little sanding drum then a guy can save on buying sanding drums. I usually do this all the time especially on the exhaust ports does a better job at smoothing the exhaust and faster then finger sanding to get that nice polished exhaust

[@aaronpowell4885]

All the little details add up!

[@tinmanssaws]

Yes sir

[@randymorris8371]

Good video thanks for sharing

[@danielflack7902]

When you grind a piston and it's 3 grams heavier than when you started. Modern life in a nutshell.

[@tinmanssaws]

Yep it's so true! I need a new scale

[@Magoot2456]

I live in Oregon, so theres weed shops on every other corner. I went in and bought my scale there and Damn is it acurate! The dude was like how can i help you? I said i need a scale that goes up to around 200g and he looked at me REALLY funny 😂

[@tinmanssaws]

That's so funny!!

[@jimyeske8498]

Put both pistons on the scale to check combined weight.

[@landondewitt8509]

I can't wait to see that thing run! Have a good one Tinman! It's Friday night in the shop for me too, anyone else?

[@stumpymcgivons1042]

Me too!

[@alltherpm]

Just bought a 372 farmac, $ 280 new, that be my next project

[@karlgarnes4783]

How much do you charge for pipes? 385xp,372xp and 395xp may want one for each. Thanks and keep up the good work. Karl

[@tdawg8605]

I know your not taking much off but I would weigh it grind one side, weigh it again then grind the other side or half. To keep it somewhat balanced. Again, it is likely minimal in difference but that's what I would do. Also would need a more accurate scale. Just my thoughts on the piston grind. Excited about the trenching of the cases. Also if you are going to delete the woodruff key where or how do you set the flywheel? For firing timing. Good stuff as always. TC Mahalo Tinman 🤙🤙🤙

[@jakegorman7121]

Drilling holes in your Pistons will also considerably lower your case pressure

[@martyrutter3630]

Another good video of closeup work on this piston. 👍👍

[@tinmanssaws]

Hey Jake, you only drill them below the ring, and they are very small.

[@longbar105d]

Friday night in the shop👍

[@bigmoustacheal3295]

BMA from Saskhere just lettin you know I'm watching, paying attention and lovin it.

[@tinmanssaws]

BMA I'm a huge fan buddy!! We're almost neighbors lol

[@mattw5729]

Excellent video thank you Sir.

[@tinmanssaws]

Thanks, glad you enjoyed it!

[@camrynrhodes798]

👍👍

[@kurtsteele5587]

How's the Tinman and famley

[@alltherpm]

Theres no way u took a couple grams off, i ground the shet outa my piston and had a huge pile of material to lose 3 grams, i thined piston, thined the inside, cut materail under pin on bolth sides as far as i dare, and at end i couldnt believe it was just 3 grams