This video covers the Review & Installation of WeatherTech No-Drill Mud Flaps for a 2018 GMC Denali To purchase this product and support our page please use the following link: amzn.to/2EuNuWm
Пікірлер: 16
@bw60782 жыл бұрын
Great video. I've got a 2015 GMC that I just purchased and I think I'll give these flaps the nod over the husky. Fingers crossed they fit as good. Thanks for sharing.
@Tableforone766 жыл бұрын
I have these same mud flaps on my 2017 gmc sierra denali. They were easy to install and look great on the truck. The no drilling is a plus!
@Fulloctanegarage6 жыл бұрын
Brian H. Cool. Thanks for watching!
@gozur73742 жыл бұрын
I bought a set of these for a 2005 Ford F-150. The box said for 2004-2008 F-150, so I know I got the right set. The mud flaps fit the contour of the truck beautifully, but the front no drill clips were in the wrong place (read useless) and most of the holes did not line up. I made it work by drilling new holes in my “no drill” mud flaps and using some self tapping screws where I needed them to make up for the fact the no drill clips were useless. Installation was far from “easy.” Looks great on the truck, but either they packaged the mud flaps wrong or there is a bad design for the earlier model F-150’s.
@DagoPadilla-lk2crАй бұрын
The came with a plastic film how is it supposed to get put on
@breadman-oc2lx5 жыл бұрын
Great install video. Ordered mine on Amazon today. Prime will have them on my doorstep in 2 days. How do you like the Goodyear tires?
@Fulloctanegarage5 жыл бұрын
I normally prefer Michelin's but no complaints with the Good Years Yet. Would I pick them again, maybe not.
@stevelee73943 жыл бұрын
Ok, so, I just installed these on my 2019 GMC Sierra 1500 double cab, old body. The fasteners on the rear flaps will not work on that model (that has the plastic around the edge of the wheel well) as the bolts for the fasteners are not long enough for the clip to fit behind the plastic and the body of the truck. HOWEVER I was able to circumvent the problem by purchasing some 1/4 in - 20 x 1in machine screws and some Loctite from Home Depot. Just in case anyone else runs into that issue.
@williamculler68435 жыл бұрын
Any rust causing issues with them me? I saw another video of a guy having mud flaps that were molded and were partially on the side of the truck and it caused some rust. Is there any need to worry about any mud flaps at all causing rust?
@elvisisalive27165 жыл бұрын
GMC is only written a dozen times on the truck, pretty sure its ok not to have it on the flaps.
@Fulloctanegarage5 жыл бұрын
lol
@locknnload4 жыл бұрын
It does not get any easier than that install!
@PunkRockerDad Жыл бұрын
The front mudflats are too short!!! Snow and mud end up on the running boards because of this flaw. These are an engineering failure!