Get your Simplehuman foam sensor pump dispenser to start pumping

Get your Simplehuman foam sensor pump to start pumping.
10oz foam sensor pump model number ST1065

[@HappyMaui2010]

Thank you !!! Her suggestions work. After 2 years my dispenser finally works correctly, an adequate amount of foam is dispensed. I cut ¼ inch off the straw and added ½ inch of water to the container.

[@dwainsouth3562]

I was about to send mine back until I tried this. Thank you so much! This worked for me 🎉

[@thesupraterrestrial]

Yessssssss thank you so much!!! Cutting the little straw worked for me!

[@lannang1070]

Glad I could help!

[@dancer4560]

ty- just bought mine at TJMAXX for $20. I love these but I have had 3 that quit working- I decided to try it again. The directions that came with it were awful

[@user-gq7jo1hu8z]

Thank you for taking your time and showed us how to repair my dispenser I was having the same issue but thankful for you it’s work perfectly. 😊

[@lannang1070]

Yay!

[@kathy615]

I'm just wondering what you do with the blue or yellow or clear tiny tubing once you cut it off a bit?? Do they connect to anything??? I probably sound really stupid. But the instructions that came with the dispenser were ridiculous.

[@lannang1070]

I just threw the small part of the tubing that wasn’t attached to the soap dispenser away! No worries the instructions were really bad

[@dancer4560]

I just set it to charge and what color should it be when it is fully charged? Mine keeps glowing off and on in a green color... TY SO MUCH

[@lannang1070]

Green is fully charged! Sorry for the late response!

[@lannang1070]

Solid green is full, blinking green is in process of charging