GolfWRX Shop: Building a Bench Ruler

[@bradley2424bw]

What is the measurements on where to place the iron back stop and where to put the ruller that's where I am confused

[@tucker35Ire]

Thansk Ryan being waiting for this. Cheers.

[@wescaddle1]

Great video Ryan. What about a jig for installing grips straight like you have on your gripping station??

[@jeffreyprice2982]

Thank you very much for posting this. Well done!

[@dcloder]

I followed these steps closely but I was still about a 1/4in out. I went to my local club builder and had him measure my 6 iron, I then adjusted the timber (which I have since replaced with a single dowel like proper rulers have) til it was correct. I also very carefully wrote the measurements directly onto my workbench. I priced a ruler of that length and I have no idea how one can cost less than US$25. Was not paying over $200 for a stainless steel one. Great video on all accounts.

[@soupy01833]

i would also like to see how you measured to place the block at the end

[@scottvg4]

Great video Ryan!

[@Kridian01]

Doing this right now! *RIGHT NOW!* 👊💥🛠

[@westonmaughangolf7029]

Nice work man! So handy!

[@333brooky]

Thanks for this Can it be flipped over to measure left handed even though the ruler would be on the other side?

[@-Thunder]

I put together something like this for putters. One thing I'd recommend is having at least one club measured by a shop so you have a known good length and can use that club to verify you're set up right.

[@jamieryan5242]

How would you set it up for measuring left handed clubs?

[@franks62591]

So the measurement is through the center of the hosel, and not necessarily along the back edge of the hosel, correct?

[@travissherriff3368]

This si something I would like to make but the explanation of the jig and measuring lie went over my head! Time to do some more research I guess!

[@wellygirl1]

does not tell me a thing about where and haw the pivot for the angle block was positioned

[@glend3139]

Agreed. The essentials are missing on where to place the pivot etc. a second video or a written response is required to make this idea useful.

[@paulp2055]

Thanks

[@philippyle3948]

Where is the second dowel ? Under the pivoting block ? How's does that block attach ? Where does it go. Video needs redone. Sorry.

[@malcolmbosanko2007]

A good idea but, do you really need to speak to people as though they're four years old?