HANDS ON! GREE Single Zone Mini-Split Full Installation

Sure it's a Tech 90 (minutes), but it was worth going overtime 15 minutes to bring contractors and distributors alike a full installation of a single zone mini-split unit for a garage in Tennessee.
Learn the essentials of a GREE single zone mini-split installation, from unboxing, mounting, flaring, pulling a vacuum, leak testing, wiring, and charging, to that final high five from a job well done.
Courtesy of your GREE Comfort HVAC tech team, who is always by your side.

[@UncleEarlHeatingAirCondition]

Nice post, never " too" much information!

[@GREEComfort]

Well you came to the right place! We just did nearly 3 hours of training for a 90-minute broadcast on the FLEXX! kzbin.info/www/bejne/faqoqIiOeJufnaMsi=gnKYOJmniav-DCBP

[@hvacinstalacije1985]

Based on R32, it is allowd to flare connection be inside of room, since R32 is slight flameble!? The presure in heating mode can reache 500 psig.

[@famousdude1239]

Straight out the back! The drain line would be better positioned and less likely to gum up w/ slime.

[@DavidFerreiraaBF3]

I have the same navac flare machine and it always over flare the 5/8 tube, it can be perfectly calibrated for all sizes, but the 5/8 will always be too big, i just ajust it by eyes now when i put it in the block, and i will usually get it right on the 2nd or 3rd try, never the first time lol, navac should look into it

[@GREEComfort]

Thanks for sharing your experience with us.

[@salvatoregiovanni8967]

What brand of lineset and insulation is that?

[@paullund6381]

Nice video 🧐 as to what not to do when installing 🧐😂🚶‍♂️💨

[@GREEComfort]

Awesome! Please share some tips and tricks with us.

[@salvatoregiovanni8967]

@paullund6381 Wtf are you talking about? I assume you’re just trolling, because this install was absolutely textbook.