Hatsan Hercules Bully: How to Tune and Adjust the Power

Travis shows how to adjust the power and tune the Hatsan Hercules Bully to get more shots and a flatter more consistent shot string.
Another Airgun Essential from Airgun Depot!
Hatsan Hercules Bully: www.airgundepot.com/hatsan-he...

[@paulgroth3345]

Thank you Tyler just the information I was looking for as I research the 45 caliber hatsan bully

[@tranceuniversetherapy5905]

Please make a video with a Hatsan Hercules (2 X 500cc) Two videos, one of how to acess the hammer spring and another video of how to acess the air outlet valve (where it hits the hammer) i have the Hatsan Hercules 1.000cc, and would like to know how to acess these two zones, Thanks!

[@phillipmendiola1257]

Totally diffrent power ajustment from the bullboss 25cal , awsome vidio Airgun Depot

[@airgundepot]

Thanks Phillip!

[@aidanharvey738]

I just ordered the bullboss would like to know how you done it

[@mikekupetsky6879]

Is your information about turning to the right to increase correct because that is opposit of my AT44 and also my flashpup

[@heikot.3958]

Travis, got a quesion, can u tune the hatsan hercules ( the normal one 2x500 ccm) even in this way ? is there a video u have done or Know one ? Thx

[@stefanalexa2113]

Hello, I have a question. If I have a weapon like Hatsan Hercules Bully can I change the size of the pellets with a smaller caliber only by replacing the pellets and the warehouse? I mean not to change parts of the weapon such as the pellet pusher, but only the pellet store. I would like to buy a weapon like this but I don't know much about compressed air guns, and I want to find out. Please answer me .

[@julionnieves5685]

Hello sir can you please made the same video with the Hatsan AirMax please thanks

[@jellywaltz6334]

The magazines keep falling out of my bully, is there a way to tighten them???

[@Jesusreyes-in6xi]

Awsome!!!!

[@michaeldagan1181]

Did anyone have been done adjusting the .357 Hercules bully yet?

[@joverton8522]

Travis,please do a video,on power adjustment,and degassing a Hatsan Flash!

[@airgundepot]

Ok, we'll try to fit it in!

[@joverton8522]

THANKS!

[@LukaszMotta]

put on youtube HATSAN FLASH FAC...

[@sosteve9113]

@@LukaszMotta would that make it even more powerful

[@khuramjaved86]

Hello, shots per fille at optimal velocity can be increased by the power adjustment (reduction in power) as you practically demonstrated in this video? Regards,

[@KGisthename]

Yes

[@wildman2346]

any chance on doing the novastar ?

[@tequiladeal]

Can I remove the air cylinder to install a bigger???

[@asoasotriadio]

How much did the power drop after the adjustment?

[@mackattack8627]

Is this tune available on the Hatsan Blitz

[@airpower7692]

How about increasing the blitz .30 cal. The fps is real low to be a .30

[@ehogimeno]

Do you know how to tune a bullmaster?

[@geooioo5072]

Can i make on my bully 45 cal?

[@AlwaysCovered1227]

Finally

[@erlingnygard4625]

Is that the same Gun as the Airmax just different Stock?

[@cheapairgunner1966]

Is it ok to shoot this over a chrony without the stock mounted, or does it have to come off/go on after each adjustment?

[@airgundepot]

You can shoot it without the stock, just be extremely conscious of safety: keep it pointed down range and watch the trigger.

[@cheapairgunner1966]

Thank you, planning on purchasing one in near future.

[@wakkerewakkere4354]

How many joule the .25 ?

[@cazador1022]

PLEASE HELP, my .30 cal bully is LOUD, anything that can be done to reduce the sound signature? by loud i mean ...no urban shooting what so ever.

[@airgundepot]

It is definitely a loud gun. We don't know of any aftermarket solutions to quiet it down, so your best bet is to drop the power down. If you drop the power down very much you'll probably have to fill to a lower pressure also to get an even shot string.

[@dannybax1982]

Get a adapter and a true ldc/silencer. Factory shrouds suck 😉 Not nearly enough length and volume to act as intended. I make my own , and up to .25 i use 1.5" carbon tube at about 10" long. For really high power .25's that need to be quiet or .30 cal and up i use 2" diameter.

[@derrickmitchell39dm]

why not just burn a pretty little hole through the stock giving you access to the adjustment screw so that you dont have to keep taking the stock off to adjust it🤔

[@erwinmaes780]

My idea too!! =:-) and why doesn't Hatsan foresee this hole standard , just don't get it

[@mohammedezat3612]

هل يوجد منها بمصر

[@sepcanino8701]

What about .25

[@CONTACTLIGHTTOMMY]

Any recommendations as to the absolute best pellet in the 45 caliber Bully? Looking for the best combination of knockdown power and range. Is .454 the best size?

[@navaxoalaska3749]

Mine is the worst airgun in the world. 45 cal horrible accuracy horrible guality horrible horrible horrible horrible trigger. With 280 grains at 10 yard's you cant hit elephant. Dont give money for trash my friend.

[@noneyabusiness88]

​@@navaxoalaska3749I've had a lot of problems out of mine. Mainly the breech seal. It keeps blowing out. Accuracy is ok but mine was set full throttle and it obviously doesn't like it. I have an AEA challenger pro in .357 and have shot around 300 rounds thru. It's absolute butter. Very accurate gun. Hopefully I can tune this Hercules bully.45 and get it to be trouble free.

[@navaxoalaska3749]

I lost my money 😭. Horrible trigger horrible accuracy horrible guality horrible horrible horrible don't do my mistake please.....i hate hatsan.