Head Gasket Replacement - HISUN 550cc UTV Engine

[@simayeux5125]

I have a grizzly 660. 2004. How do you set the timing gears on crank and oil pump

[@jameswilliam4662]

Great video!

[@Bret4207]

Everyone see how quickly Hisun got back and answered all these questions you have? Yup, that's exactly the service and response you can expect from Hisun!!! ZILCH!!!!! Also notice this video shows an engine on the bench. Yeah, wait till you try to fix this thing IN THE SIDE BY SIDE!!! Absolutely horrible to work on. BTW- these engines run a quart low on oil if you go by the factory dipstick AND no where in the manuals does it say you should be using an oil with additives for the clutch, but if you don't you'll wear it out. JUNK! But I have thousands tied up in mine, so I'm bulling on through and making this thing work for me.

[@kingminecraftersyt]

yeah 15months old my crankcase full of antifreeze, Ive had to attempt the above repair. someone said rewire the cooling fan so it'll stay running. Instead of waiting for the motor to overheat. its not easy like they show you above, but it does help, takes all afternoon at least. hisun needs to do better.

[@burtbacarach5034]

In frame top end is pretty easy.Bottom end-pull the motor.

[@joeashley7477]

Hey... Can you post a good link for the top end kit for a 550?

[@robertsrbell7811]

Do you have a veido on 2021 hisun 550 outfitter front drive shaft removal .

[@FastDaddy66]

Thanks for the great video! However you do know that nanometer is a measurement of length, I think you meant to say newton meters which is a measure of force for torqueing the head bolts.

[@yuorbevielwalierjames.3279]

Nice pattern.

[@rjosborn9862]

What are the valve clearances on it

[@СашаКорней-р4щ]

Good!! thanks

[@davevanbuskirk5455]

Is the just likebthe 07 4x4 700 qlink frontrunner i have to do the same thing and have to do soon

[@austinbuerer6632]

How do you turn then engine to TDC while on the vehicle?

[@mikedavid2233]

How do I adjust the valves bub?

[@JohnSmith-tb1zm]

I need help I have a 500 hisun we changed the valves and put everything back the way it goes and the timing looked to be right but has broken rocker arm on exhaust side twice and I can figure out why !!!!!! Timing looks good so what am I missing please help!!

[@rgxksalazar]

Why does your video going to black but still able to hear you? Need to see what you are talking about.

[@alexanderefron7342]

lots of good info, but pretty Shadetree for being from the distributor. "Torque until tight", "reuse the copper banjo washers", torque 45 degrees - I guess i'll just wing it, etc...

[@trikerider1023]

Where is the crank sensor on the 550

[@alexanderefron7342]

on the top of the flywheel side, buried under a lot of stuff

[@catfish24]

What the hell is top dead center?

[@alexanderefron7342]

if you have to ask this video is beyond your skill level

[@mxm3904]

NEWTON-METERS! not nanometers. MeTrIc SyStEm HaRd.

[@burtbacarach5034]

NANO meters for torque specs.Tuned out right there and then. DO BETTER HISUN!