I'm looking for help with getting my Cobra 146GTL in good running condition. I'm pretty handy at fixing things but need some help on what to check. I thought it would make an interesting video series about the Cobra 146GTL.
Пікірлер: 15
@mariodesmo6 ай бұрын
I would clean the switches/pots with electronic spray cleaner, and look closely at the circuit board for any loose/cold solder joints to start.
@RidgeHikerAdventures6 ай бұрын
Cleaned the switches and pots. I didn't see any bad solder joints, but I will need to take a closer look. One strange thing is now occuring after cleaning is that the radio broadcasts over the PA now. Receives but does not transmit on PA. When in the CB positions it works normal on the channels that are coming in. Thanks for the suggestions!
@darrellpeckham96796 ай бұрын
Check the solder on the pll chip and solder in the crystals 👍
@RidgeHikerAdventures6 ай бұрын
I resoldered a connection on the board by the PLL chip on a connection that didn't look like it was soldered very well, and I swear it might be a little better. When I have some time, I'm going to look it over better. Thanks for the suggestion!
@M7XCB6 ай бұрын
Looks like you need to put new electrolytic capacitors and service. I have few of these cobras 146 in my radio room great radio.
@RidgeHikerAdventures6 ай бұрын
I replaced all of the capacitors. That fixed all of the other issues except for this one. Thanks for the suggestion. 73s from 595 Lake Tahoe Nevada!
@bobdillashaw43606 ай бұрын
Looks like the pa/cb switch is in the center rather than on one or the other, not sure if that could be the problem.
@RidgeHikerAdventures6 ай бұрын
Good eye, it did look a little off. I just checked the PS position and hooked an external speaker to the PA to see if perhaps it's a bad switch. Switch checked out ok. Thanks for the suggestion!
@dxscotland59016 ай бұрын
I wonder if it could be a voltage distribution problem?
@RidgeHikerAdventures6 ай бұрын
That sounds like a good direction to go. I’ll see if I have the skills to test with a volt meter. Thanks for the suggestion! 73s from 595 Lake Tahoe Nevada!
@mikeingeorgia16 ай бұрын
Do you happen to have the schematics for it yet?
@RidgeHikerAdventures6 ай бұрын
I was able to download off the Web. Thanks for commenting. 73s from 595 Lake Tahoe Nevada!
@mikeingeorgia16 ай бұрын
@@RidgeHikerAdventures , something I did that I find to be helpful is taking the page of schematics you made over to Staples and having poster sized copies made of them. Then you can use them to trace out the circuits and draw on them with colored pencils. It’ll help you keep the various circuits organized when you’re tracing problems
@RidgeHikerAdventures6 ай бұрын
@@mikeingeorgia1 That's a great idea, I never thought of that. It would be much easier to read! 73s from 595 Lake Tahoe Nevada.