Рет қаралды 33,189
Here is my process for installing the hanger bolts in the table, legs for the current table I am building. One of the keys is making something that will hold your table legs so that you can drill into the corner of it and get a good alignment on your bolts. I made a small jig with some 45° cut pieces of plywood that would hold the table leg properly. Then I had a drilling guide that I put on top of the corner.
Once you get your holes drilled, you need to drive the hanger bolt into the hole. The easiest way I found to do this is by using an impact driver or drill. You need to add a nut followed by a washer onto the hanger bolt. Then add a lock washer, followed by another flat washer and finally a nut. This will allow you to use the socket to drive the bolt into the table leg.
You can use some wrenches or crescent wrenches to remove the nuts and washers when you have it installed to the right depth.
#hangerbolt #bolt #bolts #fasteners #table #connector #nuts #attach #lagscrew #happyaccidents #mistake #noproblem