HOBBYWING ESC Tuning on the fly - Turbo

[@yonicozac]

For a moment i was excited that you can adjust timing or something on the fly using s-bus or something. still important information. thanks

[@danjones4002]

Thats what i thought! I still dont know why you can't.

[@markakkerman-uc5li]

I run the OTA programmer on this combo and adjust the settings from the drivers stand during practice. Works pretty quick and the range is well over the 5 meters they stated to have.

[@MOONOVERMIAMI]

Hello great video information Adam

[@AdamDrake]

Thanks for watching

[@CarlosDelaoGunEngraver]

you should make a video on how to actually set up the turbo in the esc to only turn on after 90% throttle

[@malATX]

Its not disabling the turbo because its at 94%, its actually just that turbo only applies at full throttle. The HW esc considers anything above 94% to be the same as full throttle. You can confirm it by the solid green light on the esc. The "big difference" you see when dropping to 94% is the persistence of PWM drive freq vs full duty battery voltage since you're no longer ever at full throttle. Then on top of that yes turbo is now disabled. But even with turbo off, it makes a large difference being "on drive freq" vs not.

[@malATX]

Also worth mentioning the thermal characteristics will change by staying always on-pwm vs not (share of heat between esc and motor will be different)

[@Mike.rcbuggy]

hello, I compete with the mugen mbx8r eco, I wanted to ask you which motor and variator would you recommend?

[@Ev0ltion]

Wont that dean-t connector just melt in this setup?

[@anythinggarage9602]

Before switching to bullets on my batteries I ran wired packs with deans without any problems

[@AdamDrake]

Ive been running it this way for years.

[@Ev0ltion]

@@AdamDrake Oh, ok. Im just suprised as dean's connectors are rated for 25A and durinig my days of woring in hobbystore i saw fair share of melted deans and developed rl bad opinion about these.

[@jstump1972]

Is there throttle high point setting on futaba 7px?

[@AdamDrake]

Yes.

[@jstump1972]

Ok in my 7pxr it says Throttle endpoint not high point im good sorry

[@AdamDrake]

@@jstump1972 Yes, the high point is forward and low point is brake.