How Do You Know When To Change Your Chainsaw Chain?

This video shows the telltale signs about when your chainsaw chain needs to be changed. It is easy to see and understand.
🛠️ Knowing when to change your chainsaw chain is crucial for maintaining peak performance and safety. In this informative video, we'll guide you through the signs that indicate it's time for a chain replacement and provide valuable tips for chainsaw maintenance. From decreased cutting efficiency to visible signs of wear and tear, learn how to recognize when your chainsaw chain needs attention. Plus, discover proactive measures you can take to extend the life of your chain and ensure optimal performance. Don't wait until it's too late - watch now and keep your chainsaw in top condition for all your cutting needs! 🔧🌲 #ChainsawMaintenance #ChainsawTips #ChainsawChainReplacement #ForestrySkills
Become a channel member:
/ @finnishlumberjack
Please support the channel by buying some lumberjack merch: finnishlumberj...
#forestry #treefalling #felling #treefelling #lumberjack #logger #woodsman #finnishlumberjack #letitfall #precisiontreefelling #treejack #stalpen #finland #professional #professionallumberjack #treecutting #kehutanan #perhutanan #timber #pinetree #stihl #husqvarna #chainsaw #tree #treeremoval #treefelling #tiktok #treeremoval #treeservice #treeservices #arborist
#chainsaw #arborist #treework #logging #logger #treefelling #treetopping #wood #woodworking #construction #demolition #bluecollar #manlystuff #woodcutting #chainsawcarving #tree #trees #dangerousjobs #extremejobs #holzfäller #baumfäller #baumfällung #landscaping #arboriculture #sendit #husqvarnachainsaw

[@1australianbeacon]

Thx for that short and sweet video ,, hope you do one soon how you sharpen them

[@FINNISHLUMBERJACK]

Thanks, the sharpening video is just around the corner

[@1australianbeacon]

@@FINNISHLUMBERJACK take your time , its probably the most important , make good details, as those that struggle with this.

[@jackdawg4579]

I change them a bit earlier than that, once the teeth are generally less than half their starting length i will replace the chain. Chains are pretty cheap considering the run time you get out of them, so changing it out early doesn't cost much overall.

[@FINNISHLUMBERJACK]

[@rickmalaschenko3046]

Until it breaks. That mark you point out as the gauge , is that not also the gauge for your file angle, when sharpening the chain.?

[@OliverDiGeronimo009]

No, you just use the chain until it is at the max sharpening mark on the rear of the tooth.

[@FINNISHLUMBERJACK]

[@prtech7805]

This is Semi chisel chain

[@DNDikovitski]

цепь еще растягивается и при износе необходимо следить еще и за ведущей звездочкой цепи - там износ 0,5 - 1 мм, меняется обычно цепь + звезда сцепления, но лучше сразу иметь комплект: шина, 2 цепи, ведущая сьемная звезда барабана сцепления.

[@FINNISHLUMBERJACK]

[@DNDikovitski]

нет! категорически нет! 5 миллиметров до этой линии на зубе, когда круглым напильником сточили зуб до самой линии то при работе этот зуб может отвалиться! так как не хватает жесткости металла

[@FINNISHLUMBERJACK]