How I perfected my Glock 43xmos.

Рет қаралды 1,935

Sharp Thinking

Күн бұрын

Пікірлер: 19

@mr.blanco6763 Жыл бұрын

Backplate sounded gay 🤣🤣🤣🤣🤣🤣 laughed so hard

@Blade_Breakdowns Жыл бұрын

Big fan of the vids man! Been watching since the knife vids but I’m diggin the gear vids. 👊🏼

@SharpThinkingKnives Жыл бұрын

Thanks man that means a lot 🤝

@evanjames81 7 ай бұрын

I’ve got my 43x MOS on order. I’m curious why you chose to mill the slide vs run, say, a Holosun 507k with DPP adapter plate? I get Trijicon is USA made vs. China so I’m speculating it was due to reliability. I have Sig P365 XL comp and it’s plug and play for optics. Personally, I’m extremely confident with irons but I think I will force myself into the transition. I might have the 43 machined…still debating. I error on doing anything to compromise integrity of my EDC.

@SharpThinkingKnives 7 ай бұрын

I just like the rmr. It's a lot of hassle to go through for an optic but I had the trijicon tism' flare up when I got the gun in hand 😂

@garrettwelden2038 8 ай бұрын

What option did you choose from c&h after the cut? Leave bare metal, black nitride entire slide, cerakote only milled areas? Thanks

@SharpThinkingKnives 7 ай бұрын

I did cerakote because I feel that it's a better topcoat to prevent corrosion. I only did it where the cut was done

@garrettwelden2038 7 ай бұрын

@@SharpThinkingKnives thanks a lot man! I’m planning on sending mine in soon and am just looking for any possible suggestions from people who have had work done by them

@Somnio64 Жыл бұрын

is the slide susceptible to cracking since the bridge between the extractor and RMR cut is so small?

@SharpThinkingKnives Жыл бұрын

I'm actually not sure. Assuming they ran proper coolant and left enough material it shouldn't be an issue. I haven't seen any failures to date. These smaller guns typically don't see as many rounds as the 17s and 34s so I'm not surprised by the lack of failures.