How to ADJUST Base Pressure on Fuel Regulator | LS9 Corvette ZR1 | Fore Innovation F2i FPR Install

+Stay tuned for more videos...every Tuesday & Friday!
+Further SUPPORT the channel by purchasing ANYTHING thru my Amazon links below:
SUB & DONATE Here - / johnfranconh
FOLLOW - / contemporary_homestead
& HERE! - / contemporaryhomestead
Contact: [e-mail]
Thank you to the following artist(s) - Music info/credits below:
KZbin Music Library

[@Juicey3887]

What hard line and hi temp fittings are those? Look clean under there

[@olympus7632]

Very nice build, I'm using the same catch can on my ZR1 and I still have some oil getting into the supercharger. Can you elaborate on your hose routing setup for your catch can? Also what stainless bolts did you use on your valve covers and ignition coils? I'd like to pick up a set for my car.

[@JohnFrancoNH]

I have a separate video on my complete catch can system. I have zero oil in my intake and supercharger. I get a lot of questions about it. Check out my LS9 playlist. As for the stainless bolt kit i custom jeweled the heads myself. I can make you a set for a price. Thanks for watching!

[@olympus7632]

@@JohnFrancoNH Just watched the catch can video, I'm pretty sure the clean side separator is where I'm having the problem. I'll now be ordering one of those after watching your video. I'm currently in the process of installing a Kong 2650 and I'm trying to keep my setup as clean as possible. I'd definitely like a set of those screws if you send me info on pricing and where to send payment. Your routing of the wires looks amazing, I'll definitely be using some of your ideas on my build. Keep up the amazing work.

[@moe4772]

Just thought about this - so if you have dual pumps and the second pump kicks on at say 5 psi boost, how do you set the base fuel pressure then? I would think you need both pumps running to set it correct?

[@JohnFrancoNH]

the regulator will do its job automatically to maintain set fuel pressure regardless of how many pumps in the system

[@troy8940]

The engine Bay is very very clean nice very nice,😁😁😁😁😁

[@JohnFrancoNH]

It sure is! Thanks for watching!

[@jeffparis8318]

You say 78 lbs under boost but this regulator range is 25-70psi - are you not exceeding limit on this regulator? Spec on the regulator says : boost limit 250 psi - what does this mean? Sry for questions

[@JohnFrancoNH]

yes according to the fore site. BASE pressure is 25-70psi. So in my case base pressure is set to 58psi. Then it can handle 250psi according to the site. So in my case it would be base pressure (58psi) + boost (20psi) = 78 psi total. But it can support up to 250psi total.

[@jeffparis8318]

Thanks so much, I bought the wrong regulator Holley 12-846 that only supported 20-65 psi and had it on the dyno and hit a wall as my F1A maxed it out. My bad, - I have the fore system with twin 525s and should have bought the regulator long ago. Thanks for the clarification- I will place my order with them today!