installing camshaft and timing set shimming oil pump
Пікірлер: 23
@LazzMarrio Жыл бұрын
The KZbin algorithm pleasantly surprised me with this video. I'm currently doin a refresh on my gen 1 383. Wanted to check out the insides after 2000 miles and everything is perfect. So currently I have engines on my mind. The tone and pacing of this video took me back to when I learned engine building. A beautifully paced and simple visual instruction of what it's like. Simply cannot wait to see the finished block.
@Slicpartna Жыл бұрын
Thanks for the complement I'm truly excited about this build Thanks for watching
@josephscisson5253 Жыл бұрын
Man your suburban is too clean
@Slicpartna Жыл бұрын
Thanks for the complement I have big plans for the suburban I had the interior done in suede and leather Please stay tuned in Thanks for watching
@noahsimmons4107 Жыл бұрын
Hey man just curious what gen block is this? And who did you source your timing cover from?
@Slicpartna Жыл бұрын
Gen lll block, the timing cover is factory I just painted it Let me know if you have any other questions
@nunezchamp Жыл бұрын
Part 6???
@Slicpartna Жыл бұрын
Itz coming. I have it recorded, i have to edited the footage. Thanks for watching
@brianrandle83353 ай бұрын
What oil pump did you use ?
@Slicpartna3 ай бұрын
I used the melling high-volume oil pump Let me know if you have any questions Thanks for watching
@fdluid6862 Жыл бұрын
dose the stroker kit have to be specific to the 5.3 or can it just be for a small block chevy in general
@Slicpartna Жыл бұрын
You can get a stroker kit for just about any engine What did you have in mind?
@fdluid6862 Жыл бұрын
@@Slicpartna i have a 5.3 i was mainly wondering if the kit has to made for a 5.3 most kits ive seen dont mention if it was made for a 5.3 most of them just say small block chevy
@Slicpartna Жыл бұрын
@@fdluid6862 i believe summit racing has a stroker kit for a 5.3 It would be a 363
@fdluid6862 Жыл бұрын
@@Slicpartna the kit you got was that made for a ls1?
@Slicpartna Жыл бұрын
@@fdluid6862 yes the kit I got is made for a ls1 I had the cylinders bored to 3.903 to accommodate the larger pistons
@tyronecarruthers22 Жыл бұрын
How much hp u think this build will make?
@Slicpartna Жыл бұрын
It should turn over 500hp I will put it on the rollers (dyno) Stay tune Thanks for watching
@juanclemons1492 Жыл бұрын
what did you put the filler inside the water pump
@Slicpartna Жыл бұрын
I don't understand your question
@juanclemons1492 Жыл бұрын
@@Slicpartna what was the reason to put the spacers around the crank when you tightened the oil pump down
@Slicpartna Жыл бұрын
@@juanclemons1492 oh ok ok I used the feeler gauges to equally space the oil pump on the crank so there isn't any pre-mature wear in the oil pump. Let me know if you have any other questions