How to change fuel pump on a Alfa Romeo 159 (2011) 2.0 JTDM 170Hp

Рет қаралды 11,312

Күн бұрын

Пікірлер: 29

@5Dale65 10 ай бұрын

Can this pump cause problems with starting the car? Since few months I have a funny problem when I start the car first time in the morning. It looks like it wants to go, fires one or two cylinders, but then I need to crank some more to finally make it start. Changed glow plugs, removed fuel leaks, changed fuel filter, the high pressure pump seals had been replaced, I put another set of injectors and same thing. The battery is new and fully charged, starter spins fast enough I suppose. I even checked engine compression and it's over 30 bar all across the board. Last two things I suspect are the camshaft position sensor (but no errors in ECU) and the electric fuel pump in the tank itself.

@ciobotarubogdan9730 10 ай бұрын

Hi, you've done a lot of testing... very good, I have no idea what it could be. In the car in the video tutorial the engine didn't start at all... If you can understand why it doesn't work, leave a comment here... Thanks

@giorgiocandelo1598 10 ай бұрын

I have the same issue with my alfa 159 2.0 jtdm, I have changed glow plugs, starter motor, battery....but no results, the car start just with the starter spray. I have noticed that I have just 120 bar of fuel pressure during the cranking

@giorgiocandelo1598 9 ай бұрын

check my video troubleshooting about 159 won't start, I explain some solutions about this issue

@ciobotarubogdan9730 9 ай бұрын

@@giorgiocandelo1598 I saw the tutorial video, I'm glad you finally managed to figure it out🍻

@qdlaty1996 Ай бұрын

Is there any particular way the rubber ring has to be placed? I had to change the oil pump in my TBI but I cannot put the metal ring on and seal the whole pump. The rubber seems to be too thick or too big now. How is it possible? I tried to push the pump and the metal ring all the way down, together with my colleague but still the metal ring does not want to get under the metal "teeth". Without rubber everything goes smoothly but ofc I cannot drive without it. I also tried to boil the rubber to make it soft but still nothing. I dont know what to do and new rubber rings are impossible to buy, at least for petrol.

@ciobotarubogdan9730 Ай бұрын

Hi, I struggled too, the sealing gasket must be put exactly on the channel together with the new pump and closed with the metal ring .... did you manage to mount everything in place?

@WickedLeo82 3 ай бұрын

How did you diagnose that it is the fuel pump? Did you start with the diesel filter first?

@ciobotarubogdan9730 3 ай бұрын

Hello, the diesel filter has been replaced, the fuel pump does not work properly as symptoms of difficulty starting the car, sudden engine stoppage, power reduction...

@errolflynn4660 Ай бұрын

How does he hit the same direction (clockwise) to undo the locking ring, and then taps the same way to instal it again

@ciobotarubogdan9730 Ай бұрын

Hello, you have eagle eyes🙂... good observation, I didn't film the disassembly of the metal ring and as information to give you an idea, I used the same portion of the metal ring assembly video when disassembling the metal ring

@otellodeantonis 7 ай бұрын

Sorry how can unlock the seat

@geoffsharpe7584 Жыл бұрын

Did start right away 5:39

@User634-60 5 ай бұрын

Какая была причина замены насоса? Какие были симптомы?

@ciobotarubogdan9730 5 ай бұрын

The reason for the replacement was a pump failure which caused the car's engine to stall, it would not start again...

@User634-60 4 ай бұрын

@@ciobotarubogdan9730 он резко перестал работать, или было и ранее что машина глохла но потом заводилась?

@M_Marharyta 4 ай бұрын

У тебя на этом насосе нормальный разгон был? Или машина еле разгонялась?

@RedaReda-ts3tm Жыл бұрын

Merci beaucoup 🌝

@ciobotarubogdan9730 Жыл бұрын

You're welcome, I am glad that through the video tutorial you were able to help you ...

@ciobotarubogdan9730 Жыл бұрын

WATCH ALL THE VIDEO TUTORIALS BELOW : ON A ALFA ROMEO 159 (2011) 2.0 JTDM 170 Hp How to change air filter in your Alfa Romeo 159 (2011) 2.0 JTDM 170Hp kzbin.info/www/bejne/nYKbe5WrZtSVeac How to change your cabin air filter in your Alfa Romeo 159 (2011) 2.0 JTDM 170 Hp kzbin.info/www/bejne/j5Cbm6eZnKigr6c How to replace oil filter on a Alfa Romeo 159 (2011) 2.0 JTDM 170 Hp kzbin.info/www/bejne/nHWploF3i6l6oLM How to Change Engine Oil on a Alfa Romeo 159 (2011) 2.0 JTDM 170 Hp kzbin.info/www/bejne/r6Cng4qEfpWsmK8 How to replace fuel filter on a Alfa Romeo 159 (2011) 2.0 JTDM 170Hp kzbin.info/www/bejne/qKaboKCDd5t2h7M How to change fuel pump on a Alfa Romeo 159 (2011) 2.0 JTDM 170Hp kzbin.info/www/bejne/pamzhISCZat9fq8 TO SEE ALL Alfa Romeo 159 VIDEO TUTORIALS IN THE TOP BAR HOME VIDEO PLAYLIST COMMUNITY... CHOOSE PLAYLIST CLICK ON Alfa Romeo 159 AND YOU WILL BE ABLE TO FOLLOW ALL TUTORIALS WITH ALFA ROMEO 159 IF YOU LIKED THE VIDEO TUTORIAL AND IT WAS HELPFUL, SUBSCRIBE AND DON'T FORGET TO PUT A !!!!! LIKE !!!!! THANKS FOR WATCHING

@otellodeantonis 7 ай бұрын

Very nice how i can relise the seet

@otellodeantonis 7 ай бұрын

Can you help me to unlock the seet

@SinisterMKD 7 ай бұрын

You need to pull from the front side. In the middle there are also 2 hooks that are released after pushing the seat towards the trunk

@otellodeantonis 7 ай бұрын

@@SinisterMKD thanks