How to change wheel bearing on TOYOTA AYGO (AB10) | TUTORIAL RIDEX

[@brendonhughes4580]

Nice to see a proper technician using the proper tools and lubricants and the torque wrench

[@Greatglenway]

Great video ,thanks

[@anthonyenglish9298]

Great guidance, thanks.

[@kton9365]

Great,Thank you

[@farhaansidd5547]

Great video

[@thorwasanothergod7188]

Are you sure it is 175nm on hub nut? I read 216nm on charts.

[@ericguichard9417]

Je confirme c'est bien 216 Nm

[@rabfraser1234]

hi is the abs sensor ring located in the bearing or on the drive shaft ,,thanks

[@jameswhitbread7173]

It's a magnet in the bearing

[@srob4313]

Perfect 👌.

[@GucciHughes]

Good overall, some of the filmed shots would be better from different angles/close ups but helpful

[@theoracle2877]

Can you please tell me how much this costs? Thank you.

[@Enpassantful]

Good job, but you forgot to replace the dust cap at the end.

[@thrivingwithmetoday]

where is your garage?

[@michaelbmw1931]

Why dont use bearing set and dont remove all the things to take out the bearing ?...

[@rimmersbryggeri]

Because the video is for people to know why they should pay to get a pro to do it and not do it themselves and get stuck.

[@Xziriz]

Nice, but wrong torque specs, axel hub nut is 216 nm not 175 nm. Also the lower castle nut is 98 nm, not 59 nm.

[@sjmackinder]

Great if you have £500 worth of bearing press, taper splitter and 12 point No 30 socket, cheaper to go to your local garage....!

[@Wasophangen]

Aygo ab40 is the same

[@VladimirGuimaraes-v8k]

👍👍🇲🇫🇵🇹🌎

[@elbowtoe84]

Power tools matey start using them haha

[@tomthompson7400]

stick with hand tools and feel the job going well , rather than power tools and hope its ok

[@vladimirbednar7576]

Ridex? Zero quality. I bougjt a crank pulley for Q7.... after 1and half year and 10thousand km it is dead. A car stopped in the middle od road, I mušt to call a tow service..... Thanks,

[@tomthompson7400]

great video