HOW TO CLEAN A DIESEL INJECTOR AND HOW TO TEST IT// 3.0TDI// BEMU69

[@MartinMadigan-o6h]

You know your job thank you very much

[@lmxmc4]

Nice!!! Very informative. Thanks.

[@geovanybonilla2244]

Very good information, you should continue making more videos like these, they are very instructive and very well explained, greetings from the state of virginia usa.

[@bemugarage698]

thanks buddy i will, feel free to subscribe to my channel so you can watch more of these videos

[@zorkevuk]

Majstori … nema sta! 👍👍👍

[@bemugarage698]

hvala

[@electricalfive2248]

the "bracket" on the needle has a tiny bevel only on one side. the beveled edge goes away from the spring. you put it backwards. Just an FYI for next time.

[@alf3071]

if you do this then you will never have injector problems? clogging causes the coil to get hot and get shorted, right?

[@ahmadbanihasan7246]

Thanks for the Video. Is all the Injektors have 30 Nm I have Mercedes A170 cdi

[@SealofProphets]

Which country is your garage

[@BrainXTV]

Great video. Hope your work was helpfull ant the injectors work well.

[@bemugarage698]

hello, yes they are working perfectly fine

[@kaidojoosep1323]

@@bemugarage698 why did you dicided to clean? Does it have any help about "leak off" ? I guess my A6 allroad 171kw has big leak off, cause starts long and doesn't get enough pressure up as accelerate...

[@bemugarage698]

@@kaidojoosep1323 Well if it has a leakoff then this solution is not really for you, the cleaning is most for the injector nozzles, so they can spray a nice fuel pattern👌

[@kaidojoosep1323]

@@bemugarage698 So for leak off there's no fix? As if electronics are fine, by that I mean right resistance and normal metering, still leak off, so replacing nozzle part could be a fix? Not really up to install used ones ( around 70€ each in Estonia) , but new ones like 200+ euro s

[@bemugarage698]

@@kaidojoosep1323 There is people that can repair your injectors for a bit cheaper

[@viridian6903]

Does it is better to use ultrasaund cleaner

[@bemugarage698]

yes

[@stefan_jank]

Do i have to adjust something after assembly?

[@bemugarage698]

No, if you did put i back as it was no need for adjusting anything just mark each injector in what cylinder it was

[@kechokecho9980]

How much NM?

[@ruslash]

8 holes in the injector nozzle

[@bemugarage698]

thanks