How to fix Hatsan AT44-10 Magazine jam

[@paulbaker6378]

I have just got a Hatsan AT44-10 Bullpup the cocking cycle is stiff dog rough in fact when it works it's not like my Weihrauch HW100's loading mech that works flawlessly that's for sure, if this tip mod does'nt work it's only fit for the nearest WHEELIE BIN i think there.

[@carloscleber7006]

A alavanca lateral da Hatsan ar 44-10 quebrou, que resolveu o problema foi a SMS AIRGUNS de São Leopoldo RS.

[@shooterxchannel8102]

Liked and subscribed. 👍😀

[@arn8386]

I have a BT65 RB .177 caliber , all 3 mags sucks - I mean really sucks! I have tested a lot of different pellets and different manufacturers, some works better but the gun still require some force to cock and that force is damaging the pellets which decreasing the accuracy (sometimes horrible results). Most pellets are 4.55-4.58mm which raised a big questionmark why the magazines are not drilled to at least to 4.6mm. My solution was to drill the holes to 4.7mm. The goal here is of course to let the pellet fall through the magazine when the seal is not attached. Should be no resistance. Spent a lot of time with polishing, and finally cleaned it (recommend compressed air and oil afterwards. No water!). Works like a glove now. Confirm accuracy is increased (alot) at 20 yards. Pellets goes holes in holes.

[@trevor-bd4kt]

What grit sandpaper?

[@jr5406]

How do you remove the mag once its stuck?

[@tropicthunderbolt]

Lol. I only watched to see how u removed it. I just wiggle it enough, but still a pain to get out

[@ДобушбекКожомбердиев-й8о]

Магазин как синимайт