How To Fix Your Powersmart Snow Blower In Minutes: Carburetor Replacement On DB7651 That Won't Start

[@ernestleo6284]

Another great repair and thanks for taking the time to describe in detail how to replace the carburetor.

[@IndRepair]

Thanks for watching!!

[@RobertTOUB-qp6cm]

Thanks for the video. Really easy to do. Great move just replacing the carb and really good call on the Honda gasket. As in your shot my gaskets were also brittle. Probably saved me a couple hundred bucks trying to bring it some where to be repaired. Would never start with the pull now first shot every time. Thanks again.

[@IndRepair]

Awesome! Great job! Thanks for watching!

[@francislang5075]

keep the good videos coming

[@IndRepair]

Appreciate it! Thanks for watching!

[@lesleabanister]

How to change spark plug for powersmart snow blower pssw2260led

[@IndRepair]

Different engine but the same process. Use a 13/16" deep well socket or spark plug wrench. You can see from this spot in this video how to do it. Spark plug is right above valve cover (cover that says OHV on the left side of the engine) kzbin.info/www/bejne/eHaop5KbgtR6Y7Msi=_9oAAYQp7U6Lm3Dz

[@philliphall5198]

Thank You’ll for information and advice Very good job of teaching

[@IndRepair]

Thanks for that!

[@steveriggenbach90]

A lot of great information. Wish I had warm shop. It’s 25 to 35 now. So easy to forget and not inspect new carb. Take care

[@IndRepair]

It has been extremely cold for the last few days here also! Had a truck mount generator to work on a couple days ago and couldn't do more than a half hour at a time outside with the 10 degree temperatures and wind. I almost forgot what it was like working out in the cold as it has been years since working on grain bins and doing service calls that I had to do that type of thing. It's not easy! Thanks for watching!

[@akbaxb165]

Thanks for the video and thorough explanation. Question: I have a 2010 CCR 2450. What would cause a bit of oil spitting from its muffler? Worn-out oil rings? Thanks in advance for your helpful advice.

[@philliphall5198]

Check for gas in oil

[@IndRepair]

Carburetor needle stuck flooding unit with gas/oil mix,, too much oil in mixture or worn out rings. There is not a whole lot that can happen to these two cycle engines to cause this.

[@akbaxb165]

@@philliphall5198 Thank you very much!

[@akbaxb165]

@@IndRepair Thank you kindly for helpful reply.

[@redoakpropertycarellc]

Great video

[@IndRepair]

Thanks for watching!!

[@dan7102]

What NGK or Champion plug number do you recommend for replacement for the Torch? Thanks for another great video!! 👍

[@IndRepair]

We use an NGK BPR6ES on something like this

[@IndRepair]

Thanks for watching!

[@KP-oe8sk]

Nice fix!!You also gotta use 94 plus gas!! that crap gas does not play nice !!

[@IndRepair]

Ethanol is the main enemy but starting with a higher octane will help slightly. Thanks for watching!