Would've been pretty disappointing to have that happen, but glad to see you got 'er rock solid!
@castforeffect33593 жыл бұрын
It is now, for sure. Disappointed with the damage but, not much we can do now. Hopefully, this saves others from having the same problem.
@bbq101rescuesmokers11 ай бұрын
Question please, having both transducers that close to each other "Do you have any interference issues?" I have a new Bass Tracker and I am planning to mount two transducers on the rear, a Garmin GT24 for my Garmin 63cv and a GT54 for my Garmin 93sv. What are your thoughts, can I mount them as close as you have them to each other? Thanks for your time and GREAT Video!
@castforeffect335911 ай бұрын
As long as the 2 transducers are not running the same frequency, it should be just fine I would think.
@tommycodfish2 жыл бұрын
You think j&b weld would hold without the screws? Also curious to know if you sand the block and the boat before applying the J&b weld on to the boat? Is it still holding up?
@castforeffect33592 жыл бұрын
I did rough up both surfaces before the JB weld for sure. I used it on both blocks. One has the screws and one doesn’t they are both still running strong and we are on the water quite a bit
@tommycodfish2 жыл бұрын
@@castforeffect3359 awesome thanks. Great video 👍
@jamesathendune90262 жыл бұрын
Interesting, we always screwed 3/4 s of the way into the transom with lots of marine grade silicone in the pilot hole and around the screw. J. b Weld looks like a good idea also on thru the transducer block.
@msaunders300 Жыл бұрын
Hi there great video. I have a transducer block and the screws that came with my 3 in 1 are too long. What size screws did you use? I have same transducer as you
@castforeffect3359 Жыл бұрын
3/4 to get the transducer into the block
@stephenEmerson-f9z Жыл бұрын
Do you get interference? With the do different graphs?
@castforeffect3359 Жыл бұрын
Not that I notice at all
@gh50hill1 Жыл бұрын
What will you do should you want to remove/replace the plate?
@castforeffect3359 Жыл бұрын
I see your point. This is very much a lore permanent fixture. If you thought you would replace it at some point, I would screw the block to the transom. At least there would only be 2 holes?