Installing acerbis x- factory hand guards on 2023 Honda crf 250f #honda #dirtbike #handguard
Пікірлер: 19
@cody549510 ай бұрын
Thank you these are the only red handguards that actually match the Honda color on this bike
@dirtbiketrailrides Жыл бұрын
Nice video! I had the same issues putting my Acerbis hand guard onto my 250F as well, clutch lever moved closer to center, cut sides of hand grips, cut plastic on throttle end, fiddle with the inner clamp not fitting the handle bar well enough, and I managed to jam the pro taper pad in place but the edges are squished. Good of you to document these issues for others. The hand guard still sticks out past the throttle on the right on mine as well, but is still very functional. Saved my hands and levers from impacting trees / bike tip overs on numerous occasions already.
@mac197611 ай бұрын
Fantastic!
@MaxsGarajMahal6 ай бұрын
Mike Fultz said he is a friend of John, your mom and you. Said you needed some subs. Here is another. Channel is looking good young man. Good luck with the channel. Max
@northropoutdoors42786 ай бұрын
I appreciate all the help thank you
@MaxsGarajMahal6 ай бұрын
@@northropoutdoors4278 I'll try to send you some subs.
@hfuklgrekf Жыл бұрын
I just bought the white ones for my blue and white xt350 but brackets wont line up either way and to get it to line up were it goes in handle bars the retainer peice with the ears broke off so i bought a different brand hardware kit hopefully it works
@denny55642 ай бұрын
I don't think non-universal (bike specific) handguards are made ? I wish they were
@gardnerberry11310 ай бұрын
Should the wraparound bars of guard be even with the levers or a bit downward? And by how much? Thanks
@northropoutdoors427810 ай бұрын
The best way I found was to line up the guard bar with the clutch lever and front brake lever to give ur fingers and hands the best protection. They’ve saved my hands too many time to count now.
@gardnerberry11310 ай бұрын
@@northropoutdoors4278 Thanks for the quick reply! I wasn't sure how they were supposed to go so I tilted them a bit downward - about a half inch below the levers. My thinking was that: "If I down this bike, the guards may go upwards and mess with my brake line." But that likely won't happen if I just tighten the daylights out of the screws, right? 😄
@northropoutdoors427810 ай бұрын
Just snug I’ve had the bracket expand too much on other bikes and make the throttle hard to twist
@nathanwalker6624 Жыл бұрын
What size drill bit did you use to hollow it out
@northropoutdoors4278 Жыл бұрын
I used a “step bit” until the hardware fit in the bar
@Hqrm Жыл бұрын
My throttle tube isn’t hollow for a bolt? 2008 Honda CRF450R and help?
@northropoutdoors4278 Жыл бұрын
If it’s plastic, that’s what I used the step bit in the drill for. Just make it big enough for the hardware