Thanks for taking the time to educate. I feel confidant now to apply some 3m on my truck. Well done.
@FULLTHROTTLEAUTO Жыл бұрын
Great video as always. Glad you mentioned the difference between the ceramic and PPF. Really surprising to me how many people believe they both due the same thing.
@biggestsongfan Жыл бұрын
Great video. Super helpful content thank you!
@JohnChristian-mk7lj5 ай бұрын
I would like to know if you did a video of you installing fog lights on your 2023 Nissan Rogue?
@mohsenalharhara87299 ай бұрын
Thank you for the informative video. I'm considering either the 3M Pro Series 200 PPF (paint protection film) or the XPEL Ultimate Plus PPF. Could you please share your recommendation between the two? Which one offers better scratch protection for the car? Which one tends to have a longer lifespan? Thank you.
@Bsweet7 Жыл бұрын
This was very informative. However, you only showed how the alcohol solution worked once. After you finished fitting the film, heat gun, etc...is that when you applied the alcohol solution?
@dial2fast Жыл бұрын
The tack solution with the alcohol can be used anytime during the installation when you need to flush out the slip solution and get the edge to tack on faster. If you only use the slip solution, you will find the film might be too slippery and hard to tack down.
@rhuynh4 ай бұрын
I still don't quite understand. Sounds like you don't need to cover the back with tack solution as if gluing it down...you just use strategically where you need it. The film stick to the car otherwise with out it if you squeegee out the slip solution?
@isaacscales312011 ай бұрын
I have a 2021 Nissan Rogue does does the adhesive match the 2023 . Thanks
@dial2fast11 ай бұрын
The PPF film kit shown in the video is for 2021 and newer Nissan Rogue (as long as your Rogue is the same look as mine).
@pleaseletitgo1818 Жыл бұрын
Adhesive lines are definitely present due to peeling back film but with a white vehicle, you won’t see it.
@verynickАй бұрын
For $300 diy I will take it. Shop wants 1000$ for just the bumper
@ostbob410811 ай бұрын
Is there a way to prevent dirt from accumulating along the films exposed edges???
@dial2fast11 ай бұрын
If there is dirt accumulating 'under' the edge, then you can use a sharp knife and cut off the extra bit that did not adhere to the car. But as far as dirt collecting at the edge of the film, that's one downside of a computer cut film. You can still buff out the dirt with some polisher or wax but the edge can collect some dirt.
@janimba997 ай бұрын
How much cost for Nexon facelift?
@Riff6524 күн бұрын
Not a good job of explaining when to use the tack solution. I was always wondering when it was used.