How to install detachable tow bar to Skoda Superb II

[@nikolaradosavljevic6842]

Awesome tutorial I was trying to find this whole month Thank you😄

[@diaconucatalin9888]

Very nice video. Congrats for the work and patience put into making it. I have to do this operation on a Superb 3 with an original trailer module. I have now a better idea about where I have to place the module and wiring now. Thank you :)

[@ThePapomba]

09:20. Pull this part up after releasing the lower part. Don’t forget to disconnect airbag cable. I would recommend remove negative battery cable. In this case you will not get an error

[@Feldjaeger88]

Thank you so much to helped my install the tow bar and assamble the cable till the fuse box.

[@SalsamichaelA]

Super video! Any suggestions on how to remove the heat shield fastener clips without destroying them?

[@vladimirnikolovski1166]

There are the same with the 4x4 model? I meant for the tow bar

[@ThePapomba]

Why have not you activated “trailer” in engine and esp modules?

[@bohumilfunda8277]

Pěkná práce moc díky

[@jjcc80]

Hello, just 1 question, the Bk/gr cable (no.8 in Fusebox) doesn`t need to be powered ? like the other 3? I am sure that you do it correctly but i try to understand why it doesn`t need to.

[@amgtim4636]

Well don. Svaka cast majstore bravo.

[@dom1982c]

Hi, great tutorial. I’m having issues removing the three disc type bolts on the heat shield. They just seem to spin and not release... cheers Dom

[@lutz6441]

These disc type bolts are quite often in rust and it´s more convenient to break them in opening. Discs are not very expensive and it´s wise to replace them, when opening heat shields.

[@baraba054]

is this for 13 plug or 7 plug ?

[@lutz6441]

7 plug!

[@MrIosipIonut]

Hi. Did you also replaced the rear axle coil springs? I saw that are different color code for vehicles with factory trailer hitch.Thank you for your work!

[@lutz6441]

No, I leaved them as is. But as Greenline has quite low height, then its worth to change all springs.

[@MrIosipIonut]

@@lutz6441 OK. Thank you very much!

[@philipdavis_ie]

Hi, could you share the details of the long coding of the 69-Trailer module? I've a new module that isn't coded yet and I think that's why my install isn't working (yet I hope!)

[@lutz6441]

Here you go: 01 00 00 02 00 00 00 00

[@philipdavis_ie]

@@lutz6441 thank you for your help with this 11 months ago, your video and reply helped me get the tow bar installed on our Superb

[@lutz6441]

Very good to hear, that this video helped you out!

[@janbeylegaard8770]

Great video! This video saved me good money and really got me inspired!

[@lutz6441]

Thank you! Good to hear, that this video is useful for others as well.

[@H3adFUc3r777]

Good job 👏🏼

[@Nackuk]

great video, gets all the points :)

[@robertkerekes4538]

3 pin 43 44 45 oke and 1 pin take power from fuse panel constant power line Pin 8 fuse 5A ???

[@MrMili000]

Velice Děkuji !!!

[@paulshelley4670]

What/how did you use to get into the coding at the end of video?

[@lutz6441]

Maybe I didn´t understand your question, but I use VCDS version 15.7 for coding.

[@paulshelley4670]

@@lutz6441 so a normal plug in obd reader?

[@lutz6441]

@@paulshelley4670 Yes, normal OBD reader cable with VCDS software.

[@staffysmile3325]

I feel like if I did this I’d have 6 left over screws at the end 😂

[@popeycip14]

Hi Lutz, super video and very useful, I want to make the same process for an Octavia 2012. The process is similar but to conect the electric kit in panel I have somthing difference colors, pleaee help me wit an instalation guide for my car or a link from where to download. Thanks a lot Ciprian

[@lutz6441]

Yes, it can be so, that Octavia set is a bit different than Superb, but in general they are the same. I don´t have instructions for you, but you can search it from Briskoda forum, most likely you´ll find some answers over there.

[@popeycip14]

@@lutz6441 Hi Lutz, I made the installation and also on my Octavia 2 FL is totally the same like in your case. I made it in December but now I remembered to give you this feedback. Thanks for your patience to made this video. Have a great day, Greetings from Brasov-Romania

[@lutz6441]

Good to hear, that this tutorial was helpful!

[@martinostrcil2684]

Thanks a lot!

[@dennisostberg5845]

Why dont show everything?

[@harraharra6585]

Oiii oiii kui asjaliku video sa teinud oled. Viis topelt plussiga. Minu poolne austus sinu suunas🤜nukid🤛🤘🤘🤘😎

[@lutz6441]

Siis on hästi, kui sellest ka teistel kasu on!

[@harraharra6585]

No ma just otsisingi seda videot taga ja sain tàpselt selle abi mis mul vaja oli. Suur aitàhh sulle.

[@lutz6441]

@@harraharra6585 Siis on hästi! Soovitan peegli upgrade ka teha, väga mugav on automaatselt lülituvad esituled.