How to Measure and Install A Custom Steel Driveshaft

[@kblank3034]

I bought my driveshaft for you guys in 2020 and it fit perfectly. No issue during the last Drag Racing Season.

[@speedwaymotors]

Great to hear!

[@FelipeMaldonado-wk4ne]

How much of the front yoke sticks out of the transmission, after you tighten the u bolts?

[@brentmcmahon8188]

My aluminum drive shaft has been beat on from the start it has been great it is bullet proff !!

[@cliffnicholson5265]

With so much weight still to be added to that build wont the ride height be different?

[@gregturpin5631]

I'm restoring a 1970 Chevy c/10 short bed and I'm going away from the 2 piece drive shaft to a one piece. The rearend is the original 12 bolt with the 373 gears mounting up to a turbo 350 and it has been lowered to a 4.5 front x 6 rear inch drop. Do you have a drive shaft already set up for this type of drop or will I need to measure for a custom drive shaft for my application ?

[@speedwaymotors]

Hello. You would need to measure the length you would need and then you can make a driveshaft using part number 910383 www.speedwaymotors.com/Universal-Steel-Custom-Length-Driveshaft-Kits-3-Inch-OD,332572.html

[@brentmcmahon8188]

Are they new factory ends on drive shafts or are they used ?

[@ElVic82]

Is it better to get a 2 piece drive shaft like the original or go with a 1 piece? My project truck is not stock anymore.

[@patpowell862]

Hey I enjoy your videos. I have a question. I'm building a custom car with a chrysler 300 drive train V6 and automatic transmission. My design includes moving the drive train rearward to allow a 22" yes " 22 inch" custom driveshaft allowing me to only make changes to fluids and linkage connections and retaining the rear end. Is my dream too far out there?

[@theshark2804]

Have a 4l80. Should i use grease on tue slip yoke?

[@tylerseabook9423]

May-sure

[@adamcogswell6836]

Get a better ratchet. Lol

[@editz3234]

Measure.. not mEeAAsurre