How to Pull a Well Pipe and Well Point using only Hand Tools and Hoist Pulley

Рет қаралды 42,379

Күн бұрын

I pulled my 20 foot well pipe (24 foot well) to change a clogged well point after getting cloudy well water and reduced well water flow. I was able to use only hand tools and a hoist pulley with pipe fittings and adjusting rigs. Disclaimer: One must be cautious because at times excessive tension could cause equipment failure or cause bodily injury.

Пікірлер: 11

@TheArizonaOutriders 2 жыл бұрын

Great job, we are in the process of pulling our deep well pump in AZ. 600' yeah, our water is deep. I'm thinking of posting a video on The Arizona Outriders. There are a few off roaders who have stolen my name, but search and you will find. Give me a few days after Sept 4 2022

@farmfitnesspham4913 2 жыл бұрын

Yes I am been looking for a video like your thanks you very much

@AB-cr5fl 5 жыл бұрын

Hey great vid. I couldn't find the follow up one where you were putting it back in. Did you not end up making that?

@freedomaintfree1030 2 жыл бұрын

I have a 72' well that hasn't been used in 30 years. Want to get it working. 2" galvanized with a 1 1/4 intake line. Thinking check valve may need replacement but now, after watching your video, point may be rusted out as well. Should I just hook up a jet pump and see what happens? Need to pull intake and replace check valve? Rust and corrosion ruined the whole thing? Thoughts anyone?

@wildswan221 Жыл бұрын

Try the jet pump. You might get lucky. We had a similar situation and it worked fine. Pulling all that stuff out is a pain

@freedomaintfree1030 Жыл бұрын

@@wildswan221 Thanks! I've pulled the check valves before and it is a lot of toil and sweat. I'm gonna try setting up the pump and see what happens. Like you said, maybe I'll get lucky! Thanks again!!