How to remove Renault Megane 2 Cabin air ventilator

So hey guys, on this video I am giving you a quick guide how to remove your Renault Megane 2 Cabin air ventilator (fan).
Sorry for not greatest quality, but this is due to small space there and the fact, that I had never done this before.
Any way if your car ventilator does not work, here is a proof that even without any experience it is possible to fix it by yourself.
Honestly this work will not be too easy, but it is not impossible as well, especially if you know where to look for the vent and how to get it out! Good luck!

[@m0rgg]

Sir, you have my utmost respect for having the will to record this operation for helping others. Having done it myself, your effort is commendable. People can't imagine the pain that is to access and disassemble this. Thank you.

[@JUrtanschannel]

Thank you for your kind words!

[@anterometso276]

For someone who is doing this job, you might want to remove the three bolts keeping the brake booster in place from engine room side and then push the fork leading to the brake booster forward from inside, or pull the brake booster forward from engine room side. This gives you more room when trying to take the blower motor out. Don't forget to put the bolts back. Thank you for the video.

[@jozefroman2110]

Thanks your video helped at least I knew what I was getting in to. Here is how I did it. 1. removed drivers seat completely out of the car. Just 4 screws, 1 connector and set belt. You can lie down in the car comfortably. 2. removed pedals as you did, but left everything else in place. 3. replaced FAN, got out quite easily. Used the connector hole for the brake stick that is in the way. Simultaneously slowly rotating it. 4. placed everything back. Time spent 2 hours. One more tip as first remove the brake cable connector and remove also the brake switch by rotating it 90 degrees. Don't push that switch !!!

[@basil3630]

0

[@82thamonk]

Oops! Guess I might have pressed the brake switch (white-colored). My rear break lights and now constantly on, when the car is turned on. Any ideas what else would be causing that?

[@Drj545]

Thank you so much man, without the video I would never have succeeded on this.

[@dmcosta]

I've started this process 3 times already. And gave up every time. Seeing your video, I'll try again

[@apostolosbratis4236]

Thank you very much for your video, really it is very helpful. Very hard work but you manage to record also. A lot of experiance and save money. Thanks again.

[@user-gh1fg5kc9s]

I will try and see if I can do it. I have a new one but after seeing you I belive it just the same problem. It looked hard but you are good man.

[@SuperCochiloco001]

Po tym jak mechanicy w okolicy demontowali cała deskę rozdzielcza żeby wymienić wentylator po czym zamontowali go krzywo ten film uratował moje megane. Dzięki

[@lilpas68]

Nice and very useful video ! Dismounting the air blower in a Megane II turns out to be a torture ! The toughest part consists in making enough room for the fan to slide out by removing the pedals for instance. According to the vehicle technical guide, you can make additional space by remove the vertical metallic plate that stands on the side of central console. Removing it is an extra effort since one (out of 4) screw is almost impossible to reach and remove. Big disappointment, once removed the blower works quite well. Nothing wrong with the fuse neither. No clue about what can be wrong. Awaiting an endoscope to have a closer look inside the blower and heat radiator...

[@m0rgg]

Did you try changing the resistance module? They tend to fail often

[@82thamonk]

Went through the ordeal and everything was fine, the resistor, blower and fuse. Turns out, the blower speed 'knob/dial' seems to be disconnected somehow. Now, if I wiggle it abit or push it abit inwards and to the right, then release it, the blower stays working. All 4 speeds are fine when it's running. Have to figure out how to get to the connectors behind the dial for inspection. Really need the heat in this winter -10 degrees.

[@krzysiukrzysiulek2722]

Film pomocny. Próbowałem bez zdjęcia padała hamulca ale nie dało rady. Pedal trzeba zdjąć bo nie ma miejsca żeby wyjąć wiatrak. Tak że film mi pomógł bardzo. Dzięki wielkie

[@mikaelhaglund5472]

Thank you man, this video helped me wery much!!! One greatful from Finland winter

[@josemartincarrizales7105]

Muchas gracias me sirvió mucho tu vídeo

[@osmanuslu4583]

hello, do you know how to remove the ventilation panels on the left and right?

[@j.rcatracho5978]

Tuve la experiencia de sacarlo 3 veces de verdad la primera vez casi me doy por vencido por lo incómodo que es desmantelar esa parte saludos desde Honduras

[@marino01]

Perfect video. Thank you.

[@barongoadam8132]

Thanks very much for this video. I Will change my renault megane blower my self. The Last time it was replaced by a work Shop which charged me 200 €. That was about three times the cost of the blower hence im doing it myself. DIY

[@nikolakuzmanovski517]

Thank you for the video tutorial. I followed these steps and managed to fix my cabin fan. Did you had any problems with the brake pad sensor? When I assembled everything back, the pad was far from the pedal and the lights were always on.

[@JUrtanschannel]

hi there, thanks! No, I havent had any issues with brakes or pedal sensor, but I think it is possible to fit it incorrectly, is the pedals housing squarish upper part installed as it was before, if the brake pedal does not seems as it should be I would probably just take a part all housing and try to fit it again until I got it in the position as it was, better safe than sorry

[@pablnwf.pissoni2583]

Muy bueno! Muchas gracias!!!

[@cosmincosma8491]

Zdravo! možete mi reći i kako ste uspjeli ukloniti taj modul .... prostora je vrlo malo i neugodno i nisam uspio

[@mortezahonarpishe1463]

Thank you for your useful video ❤️❤️❤️🙏🙏

[@knur8549]

Dziękuję bardzo 💪

[@kristhian87]

Thanks a lot 🙇🏻‍♂️

[@mamonsijaja135]

Thank you, you are a true hero

[@JUrtanschannel]

thank you!

[@juliansaenzoficial8546]

Buenas quisiera saber si me puede asesorar en un problema similar mi Renault megane 1 modelo 2003 estaba trabajando bien el aire y de un momento a otro dejo de acero yo revise una semana después dónde va el aire y encontré una pacha desconectada la conecte y comenzó a medio trabajar pero mal ya que gira despacio y hace ruido y se detiene y le pegó y vuelve y medio arranca y vuelve y se detiene y cuando voy con el andando hace ruido pero gira más rápido y alcanza a soplar aire perfectamente solo que con poca potencia

[@gurcan8]

Thank you my friend 👍

[@franciscoantongonzalez9095]

donde puedo ver este video en español. Bueno

[@77DaWe77]

Thanks you very much for this video. I can't believe i done it. Because of you! Sorry for my english 😂 thank you!!! 🤩💪😁

[@JUrtanschannel]

Thanks!

[@darekdarek1349]

Dzięki bardzo za pomoc. Sam sobie pewnie bym nie poradził. Masakra wyjąć tą dmuchawę.

[@ruskostoyanov6512]

Thank you! Respect!

[@JUrtanschannel]

Thanks!

[@gurcan8]

Arızam; çalışmamaktan tutmuş söktüm kolay clio 3 2008 reno Elektronik devre temizleyici ve VD 40 sıktım yumuşadı kolay dönmeye başladı .10 numara 5 yıldız 👍

[@JUrtanschannel]

If you are stuck with final process of how to get air blower motor out after you have disconnected the electricity, here is how to do it and as well how can you get it back in kzbin.info/www/bejne/l3jaiKqVor15mLs just needed to clean it again, so this time I got a part that i didnt make that good last time

[@kostasfotopoulos2319]

Thanks man

[@victorjg7793]

Que valiente eres,madre mía luego hay que volverlo a montar,un saludo.

[@beachboy4106]

This is for a LHD car, it’s much easier to work on the RHD car. I removed the glove box and a plastic trim in foot well, and a the plastic air duct. If you push and twist the blower the sloe thing will come loose and you can wiggle it out !

[@user-kn3kf2yc8p]

About to try it on RHD car

[@itzikashtamkar2277]

how did you pull the fan out when the piston on the way...bent it?.how?

[@JUrtanschannel]

nop, you can rotate the piston and slip it through the fan blade

[@terryshove5926]

Awesome 😎

[@josepeixoto3384]

thanks for the video i have my POS 2004 1.5 dci megane half appart and did not find yet ,why the heater fan isn't running!!!! how is it possible that they make R O Y A L P I E C E O F S H H T cars like this???????do they do it on purpose,knowing V E R Y W E L L that the shht W I L L BREAK DOWN?? Where is the government and it's regulations? against the people? a-holes!!!!

[@alejandrohepp9385]

Hi friend, you had to remove any screw in the fan it self before remove it? I think you didn´t !!

[@JUrtanschannel]

As I remember, no, only electric connector, it is kind a screwed in the ventilation body by itself, but you have to unscrew it by hand and it is not very hard to do that. But to get to the vent you will need to remove other components which are screwed in places.

[@sergionicolasgonzalezcastr3587]

👌👌

[@soring5880]

How on earth did you put back the blower? I'm losing my mind here...

[@JUrtanschannel]

Not easy thing to do, i dont remember exacly how, but I remeber using a bit force + I remember that i also tried to put it back by taking a part fan(just removed the cpart that is cliped on), and then putting it back together when it is over the hardest part. Not sure if i just forced it in while it was one piece or forced it in while it was in two parts

[@soring5880]

JUrtans channel managed to put it back. Thanks for making this video, you make it look much easier than it is.

[@JUrtanschannel]

@@soring5880 true and for sure I would not like to do this again :D but any way when i tried to fix fan, I was thinking that it is hard to get it out and get it back in, but recently I had to replace clutch cylinder, cmon, I had to took half car a part just to take out gearbox... +air bleeding from the system was a lot different than I hoped it is going to be..

[@tamasszegedi5114]

but how did you get it out ?

[@JUrtanschannel]

well, it is not easy task! If you cant get it out as Houdini, I ll understand you, since it takes some nerve and luck to pull it out. In my case, to pull it out more easy, after i disconnected the electricity and took the vent out of it's socket, I removed the plastic top of the vent while it was in mid of the way out, so I could more easily rotate it and pull it.

[@tamasszegedi5114]

Thanks!

[@vitorvieira9853]

👏👏👏👍👍👍

[@atheist6598]

How long it would take a professional to change that part plus a resistant for that car ? repairshop said it takes 3 hours for my car

[@JUrtanschannel]

well it depends, if by resistant u mean heating resistor relay unit,( it should be mounted on top of the fan), then it wont take too much extra time to replace and I would say around 1,5-3h total is ok, ofc if you do it by your self and and do it e.g. second time and u know what to do, I think you can easy do it in less than 3h, if you want to do it quick and you are well motivated :) If by resistant u mean heating resistor unit, then it ll take some extra time (also depending of what RIGHT or LEFT hand drive car u got), but any way if you replace it together with blower, it will take u 2-3h. These are just my wild estimates, bcos with this Renault model most of the work will take some extra time, since parts that you usually want to replace, are hidden behind a lot of other parts you have to take a part to get that one part out and then you have to put everything back again :D

[@jezevec78]

My Megane: "Merci bocu monsignor"

[@selfian8511]

Omfg . Shit place to instal this ... a lot of work and in a service it will take a lot of money just to take it out ....

[@fallowmeoskan]

Oh my good. Plastick 😁

[@pauloisidoro2]

This and that down there these and that and this one.

[@manolemarian07]

I hate Renault engineer's!!!

[@iliderascao5793]

Charlot

[@routespatine]

Hahah!Encore un spécialiste de la torture voiture qui cass tout sur son passage

[@JUrtanschannel]

if you replace it with a new part it does not matter :) most important is that everyone can fix their own car and it is actually great process to learn and sometimes you can even save up some money and be sure that you have done work good and nothing will break after a week and if something does, second time work will take 3 times less time :)

[@routespatine]

Les mouvements de la caméra me donnent le mal de mer

[@TomikCR]

stupid car

[@hsissenbuggandora3840]

Why did you remove that pedal at all ?? Are you making fun of people !!???

[@m0rgg]

Trust me, you NEED to remove those pedals. You can't imagine how tight it is under there.

[@rastwet]

Never buy this brand 🤦🏽