This video is about All Surface Roofing & Construction.
Пікірлер: 29
@glengarbera736711 ай бұрын
Just the video that I needed to see. Parents replaced there cedar 8 years ago for 26k, and there's like 50 shingles popping up. Thank you
@rbbartho17 жыл бұрын
Tap the single up using a piece of wood and a hammer to not damage or blemish the shingle with the head of the hammer.
@nholt6 жыл бұрын
I was thinking the same thing.
@hollygolightly8048 Жыл бұрын
The only thing I would recommend is placing the shingle as far up as possible by hand, inserting two nails, tapping them in slightly and as close to the top of the shingle as possible and then use a small block of wood flush with the end of the shingle when you are tapping it into place so you aren't damaging the end of the shingle with the hammer. This will bend the nails a bit and then proceed to finish hammering them in with a flat bar. Cheers!
@readysetterrible32782 жыл бұрын
I need to replace the entire roof on a gazebo that I have … wish you were in the Pocono area I would hire you for sure
@Aaron-ge1hy Жыл бұрын
Great demonstration. Thank you 👍🏼
@mikepoint49832 жыл бұрын
Great video , a lot easier that I expected . Cheers
@simplecentrist5935 Жыл бұрын
Really cool, thanks man!
@jjsroofing8606 жыл бұрын
Angle those nails then when you tap the shake up the nails will straighten out.
@evianway5 жыл бұрын
I thought of the same thing and saw your note, but I don't think it matters, either way, you'll have a slightly bent nail if not a small start of a split. Has anyone used a dub of glue to glue the inserted shake to the above or below with no nails with success?
@ebomb4life14 жыл бұрын
Yiannis Anagnostou too much expansion and contraction
@gabrielgonzales81635 жыл бұрын
buenos videos construccion wor #1
@blueberrycornbread6 жыл бұрын
Great vidoe ! THanks !
@baylonaj10 ай бұрын
Shakes are meant to be installed on furring. They never dry out evenly installed directly on sheathing. Sadly, they are a thing of the past. You're asking for trouble using them like that.
@whales3022 жыл бұрын
How do you know if the shingle is under the paper or just tearing it up as you pound the shake in?
@JennZickell7 жыл бұрын
Semper Fi Marine
@timcory44552 жыл бұрын
How long should the roofing nails be for the ridge cap? Thanks
@davescholten1229 Жыл бұрын
2 and 1/4 inch. Unless heavy ridge caps then 2 and 3/4
@commandercontracting97267 жыл бұрын
You do realize that by setting the nails and then tapping it up you are just pulling the nails out and the shingle is no longer fastened properly?
@cravenmoorehead62195 жыл бұрын
I thought you weren't supposed to have paper under them I was told so they could breathe ?
@kevinjohnson10613 жыл бұрын
@@cravenmoorehead6219 Code requires installing both underlayment and interlayment
@jamesstockbauer12458 жыл бұрын
way too much gap on those shakes who installed that roof? eyewear needed.
@tbuzz285 Жыл бұрын
This video should be filed under "comedy" because this video is a joke. Just read all of the comments with corrections. I would suggest folks look to another video for the correct way to do this, and I pity the poor soul who hires this company to do any work. SMH.
@jesuslaperra49734 жыл бұрын
🤣😂😂😪🤫🤦♂️you don't how repair wood shingles
@MrNanah382 жыл бұрын
Why in the world would anyone put those on roofs, will not last, siding yes, roof no.
@Digiphex2 жыл бұрын
ALL roofs used to be cedar shake, it lasts 40 years.