How To Replace a Two Cylinder John Deere Clutch- Model 70

Its time for a new clutch! John Deere's engineers were thinking pretty hard on these tractors. They wanted the clutches to be an easy replacement for the farmer and able to be done without splitting the tractor. This was a pretty straightforward project. All of the parts and pieces got disassembled and reassembled easily.
This video roughly applies to all John Deere 2 cylinder tractors. Some may only have one set of sliding disc and pulley clutch disc.
The plan for this John Deere 70 is to fix the small issues, get it running, and use it haying this next summer! It’s got live hydraulics, live PTO, and a 3 point hitch. It should be a good tractor for general use!
Make sure to check out the other videos in the John Deere 70 playlist!
Parts Used:
2- Clutch Facings: Steiner part no. JDS538
2- Pulley Clutch Disc: Steiner part no. JDS545
3- Clutch Disc Adjusting Spring: Steiner part no. JDS880
These parts will work on the following models:
John Deere A
John Deere 60
John Deere 620
John Deere 630
John Deere 70
John Deere 720
John Deere 730
John Deere AO
John Deere AR
John Deere D
John Deere G
John Deere GP
If you would like a more in-depth video on how to install points and how the ignition system works please check it out here!-
• Mind the Gap! Ford 8N ...
If you would like a more in-depth video on converting your vintage tractor from 6v to 12v with a new alternator please check it out here!-
• Converting a Vintage T...
Make sure to subscribe to keep up on the progress and work done to this tractor and the many others of the fleet!
As always, thanks for watching Tractor Roy!

[@TravisDague-c6n]

Thanks for the great video. I have a 1952 70 I grew up on at my grandpa's farm. We used it for baling and discing. The clutch needs rebuilt. This was a big help. I also have a formal C like yours in video. It was the first tractor I learned to drive at a young age. Thanks again....

[@Tractor-Roy]

I’m glad it could help!

[@Marine-72]

To adjust the castle nuts your clutch should be engaged then lean the lever back towards the disengage position

[@harryhonzik2205]

Need to show how to get to the clutch bearing in order to service it. Thanks

[@harryhonzik2205]

Repair the power steering pump on a 1956 70 gas burner?