Awesome. My 2011 manual is leaking oil right at the bell housing. Thinking it’s either the rear main, the upper oil pan gasket, or both… also will need a new trans in the new future, but that’ll have to wait
@SEsGarage Жыл бұрын
Check the intake manifold gaskets as well. The lower manifold gasket will leak oil down the bell housing as well
@itsmerika15279 ай бұрын
Thanks for the help.😊
@SEsGarage9 ай бұрын
No problem 😊
@giljohnson30838 ай бұрын
Did you take the engine out? Doesn’t look like You did. I have an 2008 3.8l and looking to tackle this by myself.. Any advice?
@SEsGarage8 ай бұрын
No, the engine was in the jeep . I pulled the transmission, that’s gonna be your best bet. I have a video on removing the transmission if you’re interested in checking it out I had the transmission out because it was being replaced and I did the rear main seal while I was in there
@bryceandbrylen9522Ай бұрын
What if I didn’t mark it?
@jeffreymcmillan5516 ай бұрын
Where can I get the bolts for the rear main? 2 of mine apparently came out. Found out at my last oil change. The ones remaining have '86' on them.
@SEsGarage6 ай бұрын
I’d take one of the remaining bolts to your local hardware store and match them up! Those numbers should be the hardness of the bolt so be sure you get the same length, thread pitch, and hardness or “grade” bolt
@thomasrose5512 Жыл бұрын
3 ugga duggas. My man
@SEsGarage Жыл бұрын
The only real way to measure how tight something is!
@brianmott620Ай бұрын
I use the ugga dugga method more than I'd like to admit 😅