How to Set Up the MHK2 Wireless Controller

[@philribaudo4126]

I would like a video tutorial on how to set and program the MKH2 thermostat. If it exists please point me in the direction. Thank you!

[@handsoffanomaly7]

My thermostat is stuck on wait with the RedLink showing it is connected. My wireless will not connect even though it has been connected and every other device is connected and working.

[@jonathanswank62]

I'm having this same exact problem. Did you figure it out? Saturday so no tech support.

[@anomaly783]

@@jonathanswank62 Yes, for whatever reason it started working again the next day. I think it was something wonky on Mitsubishi's end.

[@priteshshah3754]

I’m also running into the same problem, so far no luck

[@tusharjain4903]

Can one use the Honeywell redlink thermostats to pair with the wireless receiver? Or does only the MHK2 remote work?

[@AndrewBurgess]

A video showing how to wire a third party thermostat into the kumo cloud station would be extremely helpful for operating heat pumps plus secondary heating systems efficiently.

[@emmgeevideo]

I don't think you can wire a third-party thermostat to units that are controlled wirelessly. Ecobee, Nest, etc., require 24-volt wiring that isn't available on these units.

[@SKB91]

My thermostat is stuck on wait with red link showing an x

[@SKB91]

Service tech had to replace the thermostat

[@Burnerboy911]

pull battery and shut off power to unit for 5 minutes.. very imporatant 5 minutes . this is how you reset MHK2

[@fasteam]

I need the wall plate instructions. I have read both the split-type air conditioners manual and the redling wireless remote controller kit manuals, but i did not find the wall plate instructions?